Electronics Forum | Thu Aug 22 05:27:42 EDT 2002 | zolasteven
Hi, With regards to reflow oven or furnace, when conducting a temperature profile how does one determine how many points(Parts) on the pcboard to be measured/connected to the temperature profile. And how to determine what parts to measure? Than
Electronics Forum | Mon Oct 14 03:03:34 EDT 2002 | msimkin
Mike, I have been using a fully synthetic motor oil on the links of my chains of my Hella for 7 years now, and have had no problems. As long as you do not place the oil on the fingers, where it makes contact with the PCB, then you will have no probl
Electronics Forum | Sun Jan 26 21:09:32 EST 2003 | Grant Petty
Hi, Ok, thanks for the info, and I had not considered that factor. Is this an issue related to the reflow temperature change in the oven, or a temperature change in normal product use issue? I will check out the standard, and do you know where it's
Electronics Forum | Thu Jan 23 16:59:14 EST 2003 | barry
what are the methods used out there to verify reflow oven performance or machine profiling. What intervals are good practice and is it necessary. We do product pofiles with our profiling equipment and can that be used to base your machine performance
Electronics Forum | Thu Apr 24 12:45:41 EDT 2003 | cyber_wolf
Can someone possibly post a link, or get me the specs/requirements of an Omniflow 10 reflow oven ? Air consumption, power consumption, dimensions etc... Thanks
Electronics Forum | Thu May 01 17:49:33 EDT 2003 | jym2000
Did you check board orientation into the reflow oven? (The Layout components are the same products A & B?) Regards Jesus
Electronics Forum | Tue Dec 09 10:46:58 EST 2003 | Peter
Hi. Is there anyone with experience in soldering standard smd on a pvd (physical vapor deposited) titanium surface? Are there any rules to obey? Especially concering solder paste, surface treatment, reflow profile and oven etc. Thanks
Electronics Forum | Tue Dec 23 09:53:47 EST 2003 | Mark
Hi Tony, Contact Universal Instruments Remanufactured Machine Divsion at 607-779-5143. They have a full line of remanufactured SMT equipment from printers-placement-reflow ovens. These machines are sold and supported by the OEM and include warrant
Electronics Forum | Tue Jan 13 10:25:29 EST 2004 | James
Do you have a different reel of parts. The leads could be oxidized from age. If everything else is soldering well, I would try that. Is your profile on your oven correct?
Electronics Forum | Tue Jan 27 10:57:23 EST 2004 | samaniegocesar
Hello Dave The information you sent me will be the base to start some samples, I'm doing some test with Heraeus and Indium solder paste.. I apreciate your support.. Best regards...