Electronics Forum | Tue Apr 20 13:40:08 EDT 2004 | Chris Lampron
Hey Dave, We have had problems with low RH. In a very short amount of time, the paste dries out and starts to stick to the squeege blades. We would see an increase in skips and some clogged appertures. This has only happened when the RH was 15% or b
Electronics Forum | Mon Apr 19 18:31:05 EDT 2004 | mykomark
I'm looking for an acceptable method for posting information such as ESD certification at an ESD controlled workstation. Are ESD-safe plastic envelopes available? Vendor? Are other solution available for posting information at the workstation, in
Electronics Forum | Mon Apr 19 21:31:12 EDT 2004 | dave
On posting information such as ESD certification at an ESD controlled workstation: What not use an "ESD Workstation" label and a calibration label next to each other? On ESD-safe plastic envelopes: While there's lots of different kinds on "envelop
Electronics Forum | Tue Apr 20 09:21:40 EDT 2004 | lbiggs
We use 8X10 Ziplock A/S poly bag 4 mil pink at our taping facility. We also sell as a supply. If interested or you would like more information please call Sarah Lewis at V-TEK Inc. 507-387-2039 X 148.
Electronics Forum | Fri Apr 23 11:41:35 EDT 2004 | JC
Hi, talking about ESD. Is there a recomendation for your building itself to be grounded? Lets say you are using esd wax, What happen with discharges? If wax conducts thes charge, where are they going? Do I need ground my builduing? Regards JC
Electronics Forum | Fri Apr 23 14:49:13 EDT 2004 | russ
If your building was built to any type of code it is grounded. Floor waxes by all I know are dissipative not conductive. The charge "dissipates away" from the floor Russ
Electronics Forum | Mon Apr 19 19:25:04 EDT 2004 | Jack
Can anyone have a rule of thumb for determining the minimum efficient production volume for a typical SMT line?
Electronics Forum | Mon Apr 19 19:41:46 EDT 2004 | Jack
Sorry...my ability to properly compose english prose fails me at the end of the work day. ========= My question should have read: "Does anyone have a good rule of thumb for determining the minimum efficient production volume for a typical SMT line?
Electronics Forum | Tue Apr 20 10:27:35 EDT 2004 | russ
How about how much did it cost to set-up and run vs. how much $$ you made. You should already have some established margins for your machine time? Russ
Electronics Forum | Mon Apr 19 20:14:11 EDT 2004 | andrewlog
Does anyone know where to buy or who to contact for ZCR spare parts. I am looking for a new conveyor drive motor and gearbox for a ZCR 4 zone reflow oven.
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835