Electronics Forum | Wed Nov 11 10:08:38 EST 1998 | Magnus
| | Hi, | | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent
Electronics Forum | Tue Jul 28 17:37:00 EDT 1998 | Robert Steltman
| Here is what I would do faced with your problem. First I would profile a similar board or use an existing profile. From there I would place the dummy device on the surface of a sample board with a thin thermocouple soldered to the board surface und
Electronics Forum | Tue Aug 18 12:02:59 EDT 1998 | zambri
| Hi, | Need some advice on how to eliminate or reduce the solder on finger that we are having right now. So far what we understand is that 90% of the problem is due to the reflow process where solder traps in vias causing explosion when subj
Electronics Forum | Mon Jul 27 21:10:10 EDT 1998 | D.Lange
| Hi, | Need some advice on how to eliminate or reduce the solder on finger that we are having right now. So far what we understand is that 90% of the problem is due to the reflow process where solder traps in vias causing explosion when subj
Electronics Forum | Wed Jul 15 15:35:21 EDT 1998 | Michael Fogel
Hello Mark, Here in ECI, because the nature of our products, are using the method of press fit connectors in big numbers and although we have SMT components (around 200 per board) as well as T/H components we still preferred to use press fit because
Electronics Forum | Wed Jun 24 11:59:31 EDT 1998 | Brian Conner
| What is your current solder pot temperature? Whatever that temperature is, | has it been verified/calibrated? | What kind of flux is being used? No-clean, OA, RMA? | How is the flux being applied to the PCB? | Is this problem occuring on ALL nega
Electronics Forum | Mon Jun 08 11:39:28 EDT 1998 | Earl Moon
| How do I mechanically/visually inspect BGA devices when they are soldered to a PCB for possible solder, or other, defects as a first step before part removal and further analysis? I have had board failures due to poor soldering--I think? I can pr
Electronics Forum | Fri Jun 05 13:06:14 EDT 1998 | Steve Schrader
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Sat May 30 18:09:17 EDT 1998 | Earl Moon
| Got handed an assignment for which I'm not totally qualified. Don't expect this forum to had me all the answers. Some answers are obvious as the device types are fairly self explanatory. | As everyone knows, IBM had problems with their ceramic BGA
Electronics Forum | Mon Jun 01 20:37:54 EDT 1998 | D.Lange
| | Got handed an assignment for which I'm not totally qualified. Don't expect this forum to had me all the answers. Some answers are obvious as the device types are fairly self explanatory. | | As everyone knows, IBM had problems with their ceramic