Electronics Forum | Mon Aug 25 12:43:35 EDT 2014 | freddimock
Numerous people use the Pyramax oven to process high temp solder but your success will depend upon the mass of your board. To maximize the probability of success you should use the highest convection rate (IWC) possible to enhance heat transfer an
Electronics Forum | Sun Feb 22 15:46:09 EST 2015 | slave2anubis
Hi, my name is Dacian, and i run a mobile phone repair shop in Timisoara, Romania. Lately we decided to do more advance motherboard repair jobs, and a big problem that we have is, cleaning the board after we remove the chips. We repair manly iPhone,
Electronics Forum | Thu Aug 27 11:18:05 EDT 2015 | dyoungquist
From your description I am assuming you are doing double sided reflow and parts are dropping off the bottom side when the board is run through the reflow oven the second time. A few ideas to try: 1) Are the parts that are dropping off heavier parts
Electronics Forum | Sun Mar 18 20:02:48 EDT 2018 | reckless
Thanks for your help every time! You are right table top units are a joke. For smaller conveyor ovens I found two major brands: Manix (no longer makes ovens) and Manncorp. The manncorp unit I am looking at does not have a bottom heat zone. Mos
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
Electronics Forum | Tue Feb 12 09:12:37 EST 2019 | SMTA-Joe
Hello SMTA. I'm having issues reworking QFNs inside housings with a much higher thermal mass than any typical PCB. We have had demonstrations in-house using BGA rework stations that simply don't get the job done. The problem is threefold: 1) th
Electronics Forum | Wed Feb 13 08:15:05 EST 2019 | SMTA-Joe
We recently had an in-house demo with the smaller IR bottom heater PACE machine. The machine was barely able to remove some components, but could not replace new ones at all. Also, the nozzle for the hot air would not fit in the tight areas of the ho
Electronics Forum | Thu Jun 27 03:03:57 EDT 2019 | SMTA-David
Hi, I have a small assembly line that consists of a Semi-Automatic Stencil machine, a Samsung Pick and Place, a small IR reflow oven and a wave soldering machine. The reflow oven is presenting the biggest bottleneck. The machine is a small IR (T960
Electronics Forum | Mon Jan 06 16:10:48 EST 2020 | dunks
We have the MC301N as well as the older T200N from manncorp and I have experience with the ebay T962A as well. Between the three, the T962A (with firmware upgrade) would be my choice. The T200N has a horrible software package, although a better pro
Electronics Forum | Wed Feb 19 12:59:59 EST 2020 | jerlong2020
Hi John, We had a FLIR system with interchangeable lenses and good thermal resolution for the time (15 years ago). I see the new ones now at a fraction of the cost which we paid and they have better resolution. Amazing how the infrared imaging tech