Electronics Forum | Mon Sep 16 04:24:15 EDT 2013 | JB
Thanks for the reply Larry, I've checked the springs and they look ok, I have swapped them just to make sure. What I have noticed while manually moving the head up & down, there seems to be a sticking point, I have checked the rails and they are clea
Electronics Forum | Fri Oct 24 13:00:36 EDT 2014 | markhoch
I'd check into the ASYS LSB-03 Bareboard Destacker. It isn't a gravity drop style. It uses edge clamps to clamp the top PCB on the stack and then drop it on the transport rail. So it doens't destack from bottom to top, it destacks from top down. We
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Wed Jan 06 22:04:31 EST 2016 | comatose
No, it isn't. Last year I paid mid fifties for a brand new 8 zone BTU. Air only, belt and rails, not a lot of bells and whistles. There isn't a ton to a reflow oven and the chinese ones have gotten pretty decent, which pushes the price down for eve
Electronics Forum | Fri May 20 12:14:25 EDT 2016 | strandy89
Im having trouble with and Ekra x5 machine. It works fine when up being run constantly, but if it sits for 10-15 minutes when you try to move the Y table to the front of the machine it makes a loud sound as if the table is hitting/catching on somethi
Electronics Forum | Thu Aug 18 09:46:40 EDT 2016 | jbuckley
Put anything over one of the fiducials being used in the circuit, and run the board. It will stop, and on the top right a window will pop up. Click "Skip Current Module" and it will X-out that circuit. If you are using the fiducials on the rail, rath
Electronics Forum | Fri Feb 03 08:18:53 EST 2017 | rob
To be fair, making lots of the same PCBAs of the same relatively low thermal mass is not particulary challenging for any of the major manufacturers if you have enough heating and cooling zones. Probably key for you would be local support for servic
Electronics Forum | Wed May 03 09:19:28 EDT 2017 | azdback
One of the pieces that attaches the ballscrew on the y table to the movable rail broke. Has anybody successfully replaced the ballscrew on the 500 t table? It does look labor extensive, not having done that before, it appears to be something better l
Electronics Forum | Thu Feb 08 08:56:28 EST 2018 | proceng1
yep, Phil nailed it. Also, don't put them in all 4 corners, or if you do, don't place them symmetrically. And keep them far enough from the edge that rail clamps won't block them. And make sure to put them on BOTH sides of a double sided board. Th
Electronics Forum | Wed May 22 10:14:08 EDT 2019 | emeto
Matt, we did the study and YES perpendicular to the V-score is the worst case scenario. We did a cross section and confirmed component is cracked. If you don't have power over PCB design, the easiest way is to change board panelization or even order