Electronics Forum | Tue May 19 12:09:08 EDT 2020 | greezmky
Thank you all that contributed to the troubleshooting! I measured the height of 10+ parts with calipers and found the average to be around 2.15mm. In the program height was set to 2.42mm. I reduced the height to 2.15mm. I have since ran 561 boards
Electronics Forum | Fri Jun 26 15:42:15 EDT 2020 | wolverine55
We have a vintage 2007 JT wavesolder machine that we are having troubles with our solder pot heating SSRs not energizing. Please see the attached Word document that gives the details of our troubleshooting. I suspect that the TCM has gone bad, I co
Electronics Forum | Wed Aug 26 15:10:04 EDT 2020 | jmelson
Thanks, I have ordered a replacement IO_DPRAM board from Korea, we will see if it fixes the problem. 2 weeks ago, right after I got the machine, it would go ready. After a couple days, it would no longer respond to the ready button. All attempts
Electronics Forum | Mon May 10 12:04:50 EDT 2021 | rsikora
Thanks for your reply. I haven't checked or used WinMCS for troubleshooting. Based on your reply, I looked or WinMCS within Explorer and could not find it. Used the autosearch function for "MCS" and "WinMCS" and the autosearch did not find it eith
Electronics Forum | Mon Nov 29 15:09:24 EST 2021 | saberbouras
Hi, I have experienced the same troubleshoots for our machines and computers, accroding to the expert who did the harmonics study our problem is created by the intense use of UPS, lights yes lights. The resultant high frequency variation in sinewave
Electronics Forum | Wed Apr 27 15:45:36 EDT 2022 | tey422
Well, if your operators can setup the stencil printing exactly the same all the time, then you won't need it. To me, SPI is more of consistence check more than quality check. It would be a lot more easier to troubleshoot a issue if you know you havi
Electronics Forum | Tue Jul 30 01:56:49 EDT 2024 | hostlace
Check the machine's display or control panel for any particular fault codes or warnings. These can help you understand the exact nature of the soft parameter mistake. Consult the machine's user handbook or technical literature. The handbook frequentl
Electronics Forum | Thu Oct 17 17:18:48 EDT 2002 | Leandro G. Barajas
Hi everybody, This is a simple posting to initiate a discussion on different ways to troubleshoot, improve, and control the Stencil Printing Process SPP in SMT manufacturing. There are many SPC, ANOVA and other analysis techniques that provide insi
Electronics Forum | Tue Dec 29 17:21:46 EST 1998 | Dave F
| I am looking for a questionaire/list of items that need to be addressed to determine the pros/cons and equipment, manpower, cost and lead time to determine if one should consider setting up an in-house SMT line. | Can anyone help? | thanks | | J
Electronics Forum | Tue Sep 26 14:22:25 EDT 2000 | Donna Poire
I'm trying get some help/advice/consulting on using a Contact 3SX Pick and Place machine. We've been using the machine for several months and have been successful placing parts (nothing smaller than 0805's so far). Recently, we are experiencing err
