Electronics Forum | Wed Nov 15 12:52:21 EST 2017 | georgetruitt
IMO – Look into nano-coatings for your stencil and radius all square apertures This should help out with solder paste releasing from the stencil helping with insufficient solder QFN LGA aperture design, try a stencil cut with a few different apertur
Electronics Forum | Fri Apr 06 12:31:07 EDT 2018 | deanm
Your fluxes are required to be compatible per J-STD-001. I wouldn't even attempt mixing no-clean (rosin) and clean (assuming water soluble) fluxes on the same assembly, especially if the fluxes are from two different vendors. If your paste and liquid
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Thu Jun 27 08:47:21 EDT 2019 | SMTA-John
Having success with Circuit Boards #432 Solvent Resistant Ink - Designed specifically for circuit boards. This medium dry ink is highly resistant to solvents .... It is also non-conducting. Note: this ink contains an aggressive solvent so should not
Electronics Forum | Wed Mar 18 11:27:24 EDT 2020 | slthomas
I am about to order a stencil and I can already see that I'm going to have issues. I'm hoping someone has a recipe for this scenario that we haven't tried yet. The parts are 16 mil pitch bga's, the pads are NSMD (10 mil dia. with 12.6 mil mask open
Electronics Forum | Fri Apr 03 08:34:54 EDT 2020 | SMTA-Gregory
We need to be careful with product to avoid introducing a new failure mode, namely corrosion and dendrite growth, especially those running no clean processes! In addition to heat (reflow, wave and some selective soldering processes) killing the vi
Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
Electronics Forum | Fri Jul 24 08:19:55 EDT 2020 | jordanabshire
I often need to wind a coil for transformers, solenoids, or chokes, & I typically use craft plywood for the ends and a paper tube for the center, cemented with wood glue, or Cyanoacrylate . Then, I usually give it a coat of varnish or epoxy. I am cur
Electronics Forum | Tue Aug 25 11:31:41 EDT 2020 | stephendo
yes Once I was using dewers of liquid N2 and recommended switching. I tried using air to the machine so the sensor would let the machine run. Boards went from good to a two inch icicle covering a large area. We went to a wall mounted single stage fi
Electronics Forum | Wed Aug 26 20:52:15 EDT 2020 | stephendo
One thing about liquid N2 is while it is safe, only let trained personnel near it. I believe if someone got their hand frozen on the side, it is not coming off until the dewer is completely empty and warmed up. And make sure management understands