Electronics Forum | Thu Nov 20 16:51:48 EST 2014 | joe98375
gregp: Our PTH process has not changed in many years. Our products are fairly simple as far as electronics goes and everything gets potted anyways. ~90% of everything we build is single sided TH with ~ 100 solder joints per board. Each board is ~
Electronics Forum | Thu Dec 04 10:59:02 EST 2014 | rrosera
HI, I work for a company in New England and recently had a unusually large number of boards fail after replacing a BGA on them. We use a AirVac DRS25 to remove and replace the BGA witch uses local forced hot air. We usually have at least a 90% s
Electronics Forum | Wed Dec 10 16:58:53 EST 2014 | sreejhu
Hello, yes you are absolutely correct. I agree with your point. Last week,I personally checked out my board on Heller 1088 which is a 8 zone reflow oven (4 on top and 4 on bottom) and the soldering came pretty nice. So comparing with that situation
Electronics Forum | Tue Dec 23 12:34:27 EST 2014 | deanm
I'm sure you considered acquiring a second FX-D and run them inline, the first dispensing half the board and the second the other half. That would automatically double your throughput. You wouldn't have to worry about a new process, consumables, et
Electronics Forum | Tue Dec 30 20:14:30 EST 2014 | jeff701
We've actually bought a second FX-D, which is intended to mainly handle smaller, higher-volume boards. That will still serve to improve throughput. But at the same time, we're also adding another pick'n'place machine which has a rated speed that's 2
Electronics Forum | Fri Jan 09 04:37:13 EST 2015 | jsolloway
Hi Jeff, We have both a MY500 (4 years) and a 600 (8 months) and were the first in the UK to have both. They work well for us, enough so that we no longer use a stencil printer. Like yourselves we are a high mix CEM we make about 500 different part
Electronics Forum | Fri Jan 23 16:11:38 EST 2015 | rgduval
Charlie, For the 300 cylinder (the largest Airgas sells), it's going to cost about $66/cylinder for the gas (plus delivery charges). They also charge a $99/year lease for the cylinder. Based on those costs, and a low-end N2 generator system that I
Electronics Forum | Mon Feb 09 09:00:17 EST 2015 | jax
Outside the MSD issues stated already (and I cannot provide a exact time not knowing multiple factors like Humidity levels, temps, exposure times, etc...) OSP might be the very worst finish to use in this scenario of side 1 / store on a shelf / side
Electronics Forum | Wed Feb 25 21:47:24 EST 2015 | dinhhuunam
Hi Marshall Bartel, SJ INNOTECH Printer is Best solution & Service for you ! HP-520S/HP-620S/HP-760S/HP-1000S Printing (±0.0125mm) Repeatability (±0.01mm) 0.3 Pitch QFP, 0402 Chip, Ø0.2 MBGA Speed/pressure control by printing section (5 sections) V
Electronics Forum | Mon Feb 16 22:34:24 EST 2015 | anvil1021
WEll unfortunately I know the answer to your dilemma all too well and I will make it easy for you. The Koh Young takes a miracle to program and the Mirtec has a superior software and 3D system when you have the MV9 system. Just to day I was measuring
