Electronics Forum | Wed Jun 12 14:42:40 EDT 2013 | armandogomez
Hello guys ! I am here again with a problem, right now we have a problem with a new product, the problems are with voids with the PTH we put a receptacle with terminal blades that are 1.3mm width in a pth with a diameter of 1.5mm we use a pallet to
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai
Electronics Forum | Wed Jul 03 14:16:09 EDT 2013 | horchak
Hi, I had seen your post earlier but had lost my very old log on information. First I will say that BGAs should never be placed and re-flowed with a rework station unless there is absolutely no other option, so I don't understand why your assembly ho
Electronics Forum | Wed Aug 14 13:24:18 EDT 2013 | eadthem
We just designate shelves with signs, PULL HERE, Move UP NEXT, MOVE UP 2nd, MOVE UP 3rd, We also keep paste in the incoming case, if it has one until its time to open it. Our operators are the ones who stock it and as long as they know they own
Electronics Forum | Thu Aug 08 16:18:22 EDT 2013 | horchak
Placing and re-flowing the shield is of course the most economical. But once the shield is placed and reflowed this all but rules out inspection test and rework. Reflow should not be an issue if you have a decent forced air convection oven. You may w
Electronics Forum | Tue Aug 13 06:23:51 EDT 2013 | mccabekev
We are running a Heller 1707 EXL reflow oven, but we have a temperature variation across the board. When the oven first comes up to temperature, the centre of the board is 10degC hotter than the inside rail which is a further 10degC hotter than the
Electronics Forum | Wed Oct 16 09:55:24 EDT 2013 | markhoch
Thanks guys. I can see the benefit as a CM, when you have no control over the Parts/PCBs that come in the back door. In my previous job at a CM I did often have product coming in the back door that did appear to have exceeded its shelf life, and hav
Electronics Forum | Thu Oct 31 17:42:14 EDT 2013 | dontfeedphils
YesTech makes a pretty nice machine, the software is pretty simple to learn and use. My shop runs on average 3 or so new products a week, so quick and easy programming is a must. Most programs can be done in an hour, usually less, depending on how
Electronics Forum | Mon Nov 04 05:22:14 EST 2013 | dselettronic
Good morning everyone I have read postings about Mirtec AOI, but they're not recent, so I'd like to know something about your experiences with Mirtec Benchtop MV-3. Our inspection department has now 3 MV-2HTL and we tried to make them as useful as po
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source