Electronics Forum | Wed May 24 07:27:06 EDT 2017 | stephendo
Hey all, > > We are a small electronics > manufacturing company who has been using the > solder reflow process for years, but we have been > hand placing components. We only run the system > 2-3 days per week. > > I have been looking at > buy
Electronics Forum | Thu Jun 08 16:12:19 EDT 2017 | davef
Your plater's recommendation should work fine. Your simple copper plate will work, but you'll be stepping into fighting a copper tarnish battle. Silver over the copper is a better choice. I was thinking a silver thickness of a minimum of 3 microns
Electronics Forum | Thu Jun 15 06:58:54 EDT 2017 | cyber_wolf
Hmmm.... When I clean my stencils after I run a job, it is to clean the paste off the stencil so it doesn't dry out in the apertures and on the stencil surface while it is being stored. Wiping the stencils during production is to clear the paste of
Electronics Forum | Wed Jul 12 16:21:26 EDT 2017 | bk
When i considered using one I bought a cheaper brand named aoyue which cost less then $140 U.S. just to see if it would work for what we were trying. It did work but our engineering dept wound up scrapping it and doing a redesign. I was going to get
Electronics Forum | Mon Oct 23 03:52:32 EDT 2017 | wendymm
Hello guys, I'm a new learner in PCB field. And recently, I have summarized some basic information I learnt on how to arrange the line on crystal oscillator, but I'm not sure if it is right. So I'll write it down below, hope anyone who may read my po
Electronics Forum | Mon Oct 30 10:16:17 EDT 2017 | swag
We have two selective wave machines that run all day every day. We're pretty high mix. Almost all products don't require preheat but it is nice to have in case you need it on something dense. Good reliable flux sprayer is important. Software that
Electronics Forum | Fri Dec 01 15:06:54 EST 2017 | emeto
I am not sure that is doable. Ground Aperture is very small(for the stencil blade to get in there) and very close to the other apertures. I want to say the minimum requirement for step is 6mm clearance from other apertures for the stencil houses that
Electronics Forum | Tue Jan 16 11:40:53 EST 2018 | awelektronik
Hello, i try to programm my vision system from our HS180 to place a Radio-Module (RN2483 from Microchip). On the Visionsystem, the Module are very bright! So i cant teach the leads from the module. I tryed to teach only measuring outline, but somet
Electronics Forum | Thu Jan 18 17:26:30 EST 2018 | davef
I'm aware of no electrical test for detecting voids and air bubbles. If someone was x-raying my boards and saw voids and air bubbles and they weren't happy about it, first thing I'd do is convince them that the boards a within standard. You know some
Electronics Forum | Sat Mar 17 09:21:32 EDT 2018 | stephenj37824
Hello, My company is looking at building our own led PCBs. We are looking for a complete line. So far we have looked into Europlacer with the pick and place being the IINEO+. We have also looked at Essemtec with the pick and place being the P