Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Thu Aug 29 11:56:21 EDT 2013 | kdc45
Sent program to a CP43 and the part data was not recognized. Machine message to power down and back up, so we did so. On power up, screen appeared with the following: OS Error Err Code 0001 Err task 0028 Err para FFFF Ex stat 0151 Err adrs CC400000
Electronics Forum | Thu Sep 12 20:42:16 EDT 2013 | marcelorotofrance
Jorge: Nosotros tenemos una óptica 0KM embalada perteneciente a Martín. Se la dio a Bruno cuando palmó la nuestra, sin embargo el equipo nuestro tiene el otro modelo. Si querés pasala a buscar y la probás. Estoy seguro que es la solución al problema,
Electronics Forum | Mon Sep 09 12:00:01 EDT 2013 | proteus
I have a 208 pin QFP that due to manufacture obsolescence I have to get them form the broker market. I've had several issues with the parts including; bent leads, leads that don't take solder very well, co-planarity problems, and DOA fallout after a
Electronics Forum | Mon Sep 09 16:29:56 EDT 2013 | gregp
Hi Everyone, I'm looking for some feedback about through hole assembly requirements today vs. yesteryear. As I see it, there are two main categories...legacy through hole and new through hole with mixed technology. The legacy stuff is older designs
Electronics Forum | Wed Sep 11 15:12:02 EDT 2013 | rway
"Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts?" That depends. It will still save time if your lot sizes are small, as opposed to hand placement. I would not recommend buying an
Electronics Forum | Wed Sep 11 20:36:04 EDT 2013 | action_101
UIC still manufacturers new thru-hole machines. Both axial and radial insertion models are available. They stopped making the multi-mod dip inserters in '91 or '92. And parts are easily acquired for any older models, there were a ton of machines out
Electronics Forum | Fri Sep 13 08:17:13 EDT 2013 | gregp
Hello Action_101, We are pretty much on the same wavelength as far as moving the cut and clinch and leaving the board stationary. It is the first I have heard about the cut and clinch being difficult to work on but you worked on them so your opinio
Electronics Forum | Tue Sep 10 17:40:14 EDT 2013 | caurbach
Let me start off by saying that although we pot a decent variety of products, we have never been asked to do something like this, so this is not based on personal experience. This is just my gut talking here. I suppose you could use some sort of ca
