Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Mon Jun 18 07:07:35 EDT 2012 | buckcho
Thank you for the response, but the machine selection is not made by me, I only evaluate the machines. So two days ago I visited a company that has a Viscom AOI. I had good impressions about the machine but there were couple of things I didn't like:
Electronics Forum | Mon Jun 25 03:52:24 EDT 2012 | awtm
Our Customer had detected tarnished pad on ImAg PCBA and had conducted several SEM-EDX test at the soldermask below some of the chip resistors. High concentration of sulfur was found and it can be significantly reduced after further chemical cleaned
Electronics Forum | Thu Aug 30 18:51:39 EDT 2012 | kahrpr
My first question is how many failures have you seen due to hair length I will bet zero. So upsetting your employees for something that will not reduce your failure rate by one board is pointless. However someone mentioned hair in the process that i
Electronics Forum | Thu Jan 31 16:29:26 EST 2013 | markhoch
I had the exact same issue a few years ago at my last place of employment. It happened twice within two months on two seperate peices of Crown-Simplimatic Equipment. I immediately sorced and replaced every lithium battery in all of my Loaders, Unload
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Jul 03 14:16:09 EDT 2013 | horchak
Hi, I had seen your post earlier but had lost my very old log on information. First I will say that BGAs should never be placed and re-flowed with a rework station unless there is absolutely no other option, so I don't understand why your assembly ho
Electronics Forum | Tue Jul 23 13:36:52 EDT 2013 | jsmorse
Does anyone have info on the "Cycle Steel" function on the Fuji XP141 machines. I am new to the industry and have not had any luck finding information on it. I talked to Fuji and they just tell me to leave it on, it will help with placement. We hav
Electronics Forum | Thu Aug 01 16:28:17 EDT 2013 | jimmyboz
Does anyone have info on the "Cycle Steel" > function on the Fuji XP141 machines. I am new to > the industry and have not had any luck finding > information on it. I talked to Fuji and they > just tell me to leave it on, it will help with > pl