Electronics Forum | Wed Dec 17 16:49:39 EST 2003 | adlsmt
Take a good look at Yestech. The in-line machines are under $100K with off line software. I think about $80K if you dont need side cameras. We replaced our Agilent SJ-10 with one and have been very happy with it. Last I knew the good benchtops out th
Electronics Forum | Sat Dec 06 23:54:49 EST 2003 | Dean
3000 base model 3010 adds feature 3020 adds features 3030 adds features 3040 adds features 3050...top of the line Sorry I don't have the feature list. It's things like Environmental control unit, under stencil wiper, stencil exchanger, 2d inspe
Electronics Forum | Sun Dec 21 23:17:54 EST 2003 | johnwnz
The SMART Group in the UK have a project that's been going for almost a year now where they are collating the PPM results for a range of companies and PCB complexities & publishing the averages as a bench mark for memebers. I hear that NEMI are now l
Electronics Forum | Wed Dec 10 10:36:42 EST 2003 | russ
I would contact your PCB supplier, they usually have some type of software for panel optimization. Each shop potentially uses different size panels so it is a good idea to ask them what they are using and go from there. Keep in mind that there are
Electronics Forum | Thu Dec 11 00:00:22 EST 2003 | david2002
Does anybody have the measurements for the dimensions of the CyberSentry fiducial calibration board. This is a board used to set the machine up if paramter files are lost. Our board has gone missing and cyber optics has a long lead time. We can easil
Electronics Forum | Wed Dec 17 18:56:02 EST 2003 | Chandler
Kev, You seem to have a very good knowledge of your process and can convey it clearly and precisely. My advise to you is to dis-regard the BS most of these guys churn out and follow your own gut. They will ask a s**t load of irrelevant Q's in some fu
Electronics Forum | Tue Dec 16 17:30:05 EST 2003 | davef
Tech-Mation International 952 Alton Parkway Irondale, Al 35210 205-833-4277 (fax) 4377 Phil Higgins, Mathew Bennett (sales) Eric Ford (sales) tiusa@bellsouth.net http://www.tech-mation.com We have no relationship, nor receive benefit from the comp
Electronics Forum | Fri Dec 19 10:15:24 EST 2003 | haviland
Bill--Good morning. We have several decline conveyors w/ conductive black belt Plus cool down units w/ banks of (8) fans. I believe the belt widths are 18". Would that work? Everything is in Illinois. Thanks, Nick Haviland, Electronic Assembly Machin
Electronics Forum | Wed Dec 17 10:25:47 EST 2003 | blnorman
I may have asked this question before but couldn't find anything when I ran a search. Question, after ultrasonically cleaning our boards we bake them out to drive off residual moisture. Current requirement is 24 hours @ 105�C. I seem to remember a
Electronics Forum | Thu Dec 18 15:48:25 EST 2003 | Subhash Nariani
Hello, Does anyone have experience with the PCB assembly of 0.5mm pitch chip scale packages with HASL finish? Characterization data that you can share? Tribal knowledge has it that the height variations of the solder prevent the use of HASL for fin
