Electronics Forum | Wed Dec 22 12:36:36 EST 2004 | rlackey
Hi Mark, Look on the bright side, if you want to change from HASL you've got the lead free issue which will allow you to evaluate all other finishes, and find the best one for you. Dave, have you seen any unleaded HASL finishes & any issues arising
Electronics Forum | Wed Jan 05 17:53:52 EST 2005 | SuePH
We had a contract in house that included a flex board which required an 18 hour bake at 105 degrees. The other brds got along fine with 2 hours, but the flex board would delaminate until we went to this long bake. I don't know how the engineer came
Electronics Forum | Tue Dec 28 10:04:01 EST 2004 | Mark
No delta T issues as I am not actually reflowing the component to the PCB. This is for moisture sensitivity testing as per JEDEC 020C Standard. Trying to duplicate a profile in the standard and am having trouble reaching a component ramp rate of 3
Electronics Forum | Sat Jan 08 08:50:35 EST 2005 | davef
Normally, you should not have to bake boards that are properly packaged and stored. Since you are seeing problems, baking makes sense. Consider 125C for 4 to 6 hours. Additionally, look here for more, while waiting for others: http://www.smtnet.
Electronics Forum | Thu Jan 13 04:10:48 EST 2005 | Rob
Also depends on how often you will be running the machine, at what speeds and how long you want it to last. If you're going to thrash it 24/7 and want it to last 10-20 years then a turret chipshooter will have less maintenace downtime, and be a lot
Electronics Forum | Thu Jan 13 16:00:59 EST 2005 | mgc
Fasst1, Not only are you abusing this forum with completely unveiled sales pitches (your so called soap box), you also have proven that you can't count. You jumped in on this thread yesterday. Your legs are "tired" from two days "getting on and off t
Electronics Forum | Thu Jan 13 16:16:37 EST 2005 | Grant
Hi, It is a bit hard when you want to get clear answers from people on their experience when a manufacturer jumps in, because it skews the thread. Is there anyone using an XP chip shooter? What do they think? I really like the design of it, and th
Electronics Forum | Fri Jan 14 02:49:30 EST 2005 | Grant
Hi, We don't have that to spare right now, but I was thinking about XP 142 and adding that to the current like, and then selling the MYDATA and getting an XP 242. Not sure about getting the CP model, as it's a serious bit of equpment, but would spee
Electronics Forum | Tue Jan 11 10:02:43 EST 2005 | jdumont
Good day all, we have an evaporator for our PCB washer that has been fine up until recently. Everytime we run it, it boils over and makes a HUGE mess of everything. Any suggestions as to why this could be happening? Is it possible the temp controller
Electronics Forum | Thu Jan 13 17:45:24 EST 2005 | vickt
Clark, As a start....Do you have a qualified tech on site to verify that the camera lighting is within spec? If not it's hard to say where you are starting from. I know that UIC still has trained personel that can help you out on this older gear if y