Electronics Forum | Mon Aug 03 20:17:43 EDT 1998 | Dave Kalen
(fishing).. | Has Sanyo developed a bulk feeder for 201's and do you feel that bulk feeding will be the next big move in placement equipment? | In New England people are talking bulk feeding, but few people have elected to go that way. | As wit
Electronics Forum | Fri Jul 10 12:22:37 EDT 1998 | Ben Salisbury
| We are looking for spare hard drives for the Fuji MCS computer. I believe this is an MFM drive. Is this correct? Where can these drives be found? | Thanks. I was going through the archives and came accross this one...no answer...probably too lat
Electronics Forum | Thu Jul 09 21:31:07 EDT 1998 | Dave F
There's a company out the that makes air sleds for moving equipment around. Air sleds are heavy duty plastic plastic bags with lots of little holes in the under-side. The bag is positioned under the equipment. A vacuum cleaner, hooked-up backwards
Electronics Forum | Tue Jul 14 15:21:28 EDT 1998 | Brian Conner
| We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the par
Electronics Forum | Fri Jul 10 13:58:49 EDT 1998 | Bob Willis
The parameters which effect the problem you are having are flux and contact time try first increasing the flux you are applying. Next reduce the contact time in the wave by adjusting the back flow plate. If the problem is a jig design check out the j
Electronics Forum | Wed Jul 15 15:18:12 EDT 1998 | Upinder Singh
| | We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the p
Electronics Forum | Wed Jul 22 15:05:31 EDT 1998 | Dave F
| | | | We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all
Electronics Forum | Wed Jul 08 17:31:31 EDT 1998 | Dave F
smd: I think the idiom is "schmuck," rather than "putz." ;-) What are you concerned about? That the residual water in the 80 pin connector housing will flow down the boards and rot-out the bottom of your new boxes? Dave F | I am about to place a
Electronics Forum | Fri Jul 03 09:29:19 EDT 1998 | Dave F
| Hi all. | I am trying to put one 20 pin thru hole connector along with the smt components on the PCB. I would appreciate if somebody can guide me in getting thru this process. I also need to know how much bigger the holes on the screen or stencil
Electronics Forum | Tue Jul 07 14:17:38 EDT 1998 | ETS, Inc
Dear Wayne, ETS is a manufacturer of conveyorized curing ovens for use with conformal coatings. We also happen to be the manufacuturer of the Nordson Ovens which are often integrated into the Select Coat and Century conformal coat lines. I would be h
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
