Electronics Forum | Mon Jul 15 19:18:51 EDT 2013 | microaide
Does anyone know how to make the vision alignment work on a Quad 4C? What I mean is make it work right, and reliably. I know how to define the component for inspection (lead pitch, lead count, dimensions, tolerances, etc.), and I know how to set ligh
Electronics Forum | Tue Jul 16 13:08:24 EDT 2013 | ericrr
I seem to of slipped into a mighty giant suction cup, and every day is the same. Now take yesterday as I was making a sample the start of run board, we have run many times. it got halfway placing diffused LED's 3216 (about 1207 size) then is stoppe
Electronics Forum | Mon Jul 22 12:43:31 EDT 2013 | microaide
I don't think it is a loose camera lens. We are actually off on the position of the Z-rod. It's not just the camera position that is off. We really can't change nozzles because the z-rod misses the hole in the nozzle changer. We have repeatedly clea
Electronics Forum | Thu Jul 25 00:42:02 EDT 2013 | felo188
Hello everyone! I have problem with using vision in csm v60. Below describe: 1. Machine's third head takes one IC from tray 2. Goes to vision and take picture and moves IC 3. Goes to pick and place 4. When nozzle wants to place IC on board the
Electronics Forum | Mon Aug 05 22:10:38 EDT 2013 | jaimebc
We have HRFT-301U ( staple bend) is fairly easy to set up. All you need is t-handle Allen that I believe is provided with the machine. All adjustments to form a part, both pitch and lead length are mechanically adjusted by sliding the forming and c
Electronics Forum | Thu Aug 08 11:58:25 EDT 2013 | rway
I am not that familiar with the older systems. The software should be supported on both old and new alike unless you are limited by the operating system, but the camera will obviously have a lower resolution and perhaps the filtering is not quite as
Electronics Forum | Tue Aug 13 10:09:10 EDT 2013 | dyoungquist
We have a Heller 1707EXL that we use for lead and lead-free production. It has both a mesh belt and edge rails. We run 90% of our assemblies on the mesh belt (leaving the edge rails wide open). I have noticed when profiling a board on the mesh bel
Electronics Forum | Wed Aug 14 18:19:09 EDT 2013 | jlawson
Generally the heller exl range has issues in cross profile, some machines more than others. I have see as bad as 15 deg c and as low as 5 deg c ranging from entire length to a few zones. They never match the specification in reality. The markiii is
Electronics Forum | Wed Aug 14 17:36:19 EDT 2013 | rgduval
I always prefer to not count parts, period. Generally, I don't have too many problems with customers with this method....I explain to them that the cost of my counting the parts (to them) is much more expensive than the cost of them supplying excess
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the