Electronics Forum | Wed Mar 31 06:08:45 EDT 2010 | miroyu
Hi everyone ! I started to program quad 4C for the first time and have some problems. First, board detection LED and proximity Led (on the front panel) are not lightning whatever I do! Second problem is I teach machine board size, nozzle locations
Electronics Forum | Fri Nov 06 20:43:58 EST 2020 | jmelson
Does anyone have schematics for the PC board inside a Quad IQ feeder? I have one that worked a few days ago, but now gives me blinking lights and doesn't move. Or, do you know what to do when it won't move? I have checked the contacts and the feeder
Electronics Forum | Thu Apr 18 17:42:26 EDT 2013 | navworx
Just because a feeder has 8 pins on the front > does NOT mean it is IQ. The IQ feeders started at > a certain level of feeder part number.....which i > do not remember being that many people dont use > the IQ system. > > Good Luck It has PLD v
Electronics Forum | Thu Jul 03 09:27:10 EDT 2014 | torch
Hey guys wonder if anyone can help me, having an issue with our Quad QSP2, at the moment it is displaying Tep2 - Send Status command failed Tep1 - Send Status command failed and there is no response from the gantries, the interlocks appear to be wo
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Mon Jun 16 10:52:02 EDT 2014 | robstarrs
bobpan quick background. I am very new to the Quad machines, I used to "run" one, but I never learned the inner workings of a machine. I just purchased 2 used quad 4cs, I had a training session over the weekend with a very knowledgeable guy and l
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Wed Nov 04 07:39:34 EST 2009 | vetteboy86
We have started using an RGB LED and today ran the first boards down our line. I noticed an immediate issue with placing these. I'm using a quad QSP-2. The part sticks to the nozzle. The nozzles are clean. I have adjusted machine handling so that vac
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Wed Mar 31 09:26:26 EDT 2010 | Bobpan
Hello, There should be a page in the manual that explains the proper way of manually teaching a program. It has been too long for me to recall the exact steps. Here is some stuff that should help you. Do a function 3 on a placement and this will show