Electronics Forum | Wed Aug 22 04:29:48 EDT 2007 | raf_jabil
Has anyone experienced intermittent communication issues with GSM/GDM and PCT conveyors? I have an intermittent issue where sometimes I would hit the ESTOP on the PCT conveyor(downstream) in order to get the board to eject out of the GSM/GDM. I have
Electronics Forum | Thu Dec 24 10:07:42 EST 2009 | edwaterfall01
Get two connectors to fit the SMEMA 1 connectors on either end of the machine. Need only two wires on each connector going to momentary contact sw. Input is pins 1 & 2 to switch and output side is pins 3 & 4 to switch. If this doesn't work then ch
Electronics Forum | Thu Jul 28 18:53:32 EDT 2011 | rway
Make sure your system is not in bypass mode (under conveyor setup). Also, the intermittent SMEMA signal can cause the conveyor to turn on until it times out. Check your sensor on the upstream conveyor. Cover it and check your diagnostics to ensure
Electronics Forum | Thu May 02 13:40:25 EDT 2019 | youngbuck
Hello All, I am having a issue with Siplace 80 F5 with parts placing of in the X direction after I do Zero Point Correction with tool and Full Calibration. I also do the Gantry Zero Point correction and parts still place off in the X about .200mm to
Electronics Forum | Mon Jul 20 22:07:21 EDT 2009 | mika
Hi, I just read your post. I think I know what's your problem is. In the DEK 265 (I assumed that is the model?)There is a special card for such things. For. ex. Fuji interface, Panasonic, Siemens, and UIC SMPI - interface. Uninerversal has therir own
Electronics Forum | Wed Sep 15 12:22:51 EDT 2010 | remullis
Mike, Another thing to consider is the type of switching they may use. Older Asymtek masking machines used transitors to communicate upline and downline instead of dry contacts. The problem we had with this is dropping enough voltage across them to
Electronics Forum | Fri Aug 17 09:42:18 EDT 2001 | Hussman
G'Day All, I have a couple of new Panasonic MSR's. Whenever I load a new program into the machine, I have to manually feed the first PCB onto the X/Y table to get it to run. After that, they run just fine. Panasonic is going to be in and they hav
Electronics Forum | Mon Mar 21 10:40:33 EST 2005 | emeto
Hello all, Can you tell me what standart is used for communication between machines in production line. I don't mean SMEMA. There is a standart for machine communication, they can communicate one with another. That is the way for example AOI says th
Electronics Forum | Tue Jul 06 12:25:54 EDT 2010 | isd_jwendell
I agree, setting a standard for the pcb fab shop is good. I use a fiducial a little smaller than the spec you mentioned, I use 30 instead of 40 mil, which is the minimum recommended for my machine. The rest of the spec (SMEMA Standard 3.1) appears th
Electronics Forum | Thu Jan 14 11:58:29 EST 1999 | Chrys
| | | | What's going on with Nepcon next year??? | | | | I have heard rumors allot of the big guys are moving to IPC/SMEMA show on a long beach somewhere in Calif.. | | | | | | | | Any info on who is planning to attend Nepcon 2k would be nice | |
