Electronics Forum | Wed Feb 18 13:32:58 EST 2015 | stevea
Hi Rob, Not sure if you made any decision on your SPI requirements. The recently established VisionMaster (Long history of previously shuttered business names) company sells products similar too, but not the same as the past "VisionMaster branded" p
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Fri Nov 07 14:30:32 EST 2014 | klopi90
Hello! I am a lucky user of an ALD515 AOI, a cheap Chinese machine, and I would like to aks if anybody has any experience with it? My main problem is a lack of any manuals or tutorials for learning, what cause other difficulties. I have a one main
Electronics Forum | Wed Nov 19 18:43:04 EST 2014 | gregcr
Hi All, I've been in the CM world for a long time and it seems like there has been little change in the packaging techniques used at the end of the day. Assembled circuit boards in small/flex volume are bagged or bubble wrapped and boxed up to ship
Electronics Forum | Sun Nov 23 01:38:49 EST 2014 | alexeis
Hi, We have clients who developed a similar model and even some of them turn it on for some time. The problem is the high cost of ongoing maintenance. What is true, the system allows to study weak places of pre-production and our customers were able
Electronics Forum | Thu Dec 04 10:46:42 EST 2014 | spoiltforchoice
I have no idea what your Festo looked like. But the ability to move a component freely in xyz and rotate it is what you get from a typical manual placement station. You don't get that with tweezers or vacuum pickup pens. I've seen people make all so
Electronics Forum | Tue Dec 23 10:31:46 EST 2014 | jimpat
Sounds like your volumes are pretty low. Pick and Place is the bottleneck in the assembly line. Consider an oven that can keep up with the throughput of your P&P. "The best" is determined on individual cases for a specific application and enviro
Electronics Forum | Mon Dec 22 13:54:25 EST 2014 | proceng1
My customer made a process change to overcome a design flaw. The PCB assembly mounts in a plastic housing. The PCB mounts to the front housing via plastic stand-offs. They had to change a connector on the back side of the assembly due to long term
Electronics Forum | Tue Dec 30 09:31:52 EST 2014 | rgduval
I've always approached it like this: Design your processes and perform your work to class three standards, and inspect to the standard that is acceptable. That is, all work should be performed to the highest degree of quality. When the work is ins
Electronics Forum | Thu Jan 14 04:46:03 EST 2016 | saimen
Hi There , Glad to contact with you , Here is Saimen in Tianweisheng , wish we will have a good cooperation in the furture if we have the honor . Our company is one of the largest custom-made PCB manufacturer in China. We can OEM,ODM,EMS single side