Electronics Forum | Thu Jul 07 11:52:25 EDT 2016 | proceng1
We just pulled a Speedline Accuflex printer out of storage. After programming a board and stencil, and calibrating the fiducials and everything, we do a test alignment and bring the board to print height. It is off. I've done it now with two diffe
Electronics Forum | Mon Jul 11 07:40:11 EDT 2016 | spoiltforchoice
I don't know your machine but you are looking at the most likely areas. Some machines define a placement pressure, other may define an overtravel to make sure the device is firmly placed on the board. There are usually also timings for when the vacuu
Electronics Forum | Mon Jul 25 09:45:39 EDT 2016 | spoiltforchoice
How do you answer that question? You probably won't find anyone who has worked with both which leaves them comparing datasheets just like you presumably already have. http://www.e-by-siplace.com/28657/E-Performance/Overview/e_series_stage.aspx?slide=
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Fri Jul 29 06:16:19 EDT 2016 | dmsm123
We do have a commen problem with flux residues after the wave soldering process, even after using correct wave soldering profiles recommended by the flux supplier, The following flux type is being used Alpha EF 2210 VOC Fre Bellcore No Clean water Ba
Electronics Forum | Mon Sep 12 03:38:03 EDT 2016 | rob
Hi John, We picked up a used laser marker (Asys ALS03) last year for around 30K euros and it has done approx 2M codes (we use 6mm square QR) in the last year without fault - it reads them all back to confirm which is handy. We also use labels, and
Electronics Forum | Wed Sep 14 07:37:56 EDT 2016 | awhite
Thanks for the link, Ive actually always wanted to learn Italian :) Unfortunately, because this has been an issue for about 2 weeks now, I think Ive read almost everything ever written about SMEMA protocol. The process seems so simple, it's killing m
Electronics Forum | Tue Sep 13 19:06:49 EDT 2016 | dontfeedphils
Well I've tried to get in touch with Ovation for weeks now without luck, so maybe someone here will have the answers I'm looking for. One of our Grid-Lok Gold modules is leaking air from the sides (it pushes the pins up fine, but when air is applied
Electronics Forum | Thu Sep 22 13:05:29 EDT 2016 | chabscan
Hi I would like to know the process in wich the Quad 4C knows it has the correct component after taking it from the feeder. Recently I've been put in charge of a Quad 4C machine that is used to assemble two different boards. Each one has already a