Electronics Forum | Sat May 07 13:09:14 EDT 2016 | embidd
First off, let me say hi to everyone in the forums. This is my first post but hopefully not my last. Okay, so the other day I decided to take my graphics card apart, and in doing so I clipped one of the wires that connect the fans to the fan header
Electronics Forum | Fri Sep 09 06:10:03 EDT 2016 | jswatt
the time between SMT & wave should be as short as possible but at a max it is controlled by strictest MSD part, so if you have a part with only a 48hr MSL window then it needs to be with the 48hrs. Can you post images of what you are getting? It may
Electronics Forum | Fri Jun 03 12:44:46 EDT 2016 | cyber_wolf
"and most importantly inexpensive" Define inexpensive... I always get fired up about "expensive" Expensive compared to what is my question ? A car? a house? If you want what you are speaking of, you will be spending some coin. If you want, semi r
Electronics Forum | Fri Jun 03 09:17:00 EDT 2016 | designhaus
Hi, > > if I were you, I would probably go for > testing and rework equipment. Adding > manufacturing to your business, will most > probably exceed your preliminary expectations. > Manufacturing is much more complicated than you > probably thin
Electronics Forum | Fri Jun 10 12:48:55 EDT 2016 | deanm
Kyle,thank you for steering me back on track. For relays and connectors I like Tom's suggestion provided you are allowed to add materials to your assemblies. An instant adhesive or perhaps a chip bonder (used in SMT) may work if the preheat is high e
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim
Electronics Forum | Thu Jul 07 11:52:25 EDT 2016 | proceng1
We just pulled a Speedline Accuflex printer out of storage. After programming a board and stencil, and calibrating the fiducials and everything, we do a test alignment and bring the board to print height. It is off. I've done it now with two diffe
Electronics Forum | Mon Jul 11 07:40:11 EDT 2016 | spoiltforchoice
I don't know your machine but you are looking at the most likely areas. Some machines define a placement pressure, other may define an overtravel to make sure the device is firmly placed on the board. There are usually also timings for when the vacuu
Electronics Forum | Mon Jul 25 09:45:39 EDT 2016 | spoiltforchoice
How do you answer that question? You probably won't find anyone who has worked with both which leaves them comparing datasheets just like you presumably already have. http://www.e-by-siplace.com/28657/E-Performance/Overview/e_series_stage.aspx?slide=
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
