Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Mon Nov 14 17:17:02 EST 2016 | defakto227
Just from my recently acquired experience working with wash chemistry. Some will have issues with foaming as the concentration of wash chemistry goes down and the temperature of the wash goes down. Over a few washes you may be seeing a reduction
Electronics Forum | Wed Oct 11 04:09:05 EDT 2017 | leeg
We are using a connector on an assy whereby every now and again its raising up on one corner, we have been advised we should weigh them down to ensure flatness, this is the 1st time I've come across having to weigh anything down at SMT reflow? Any ad
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Fri Mar 06 14:33:53 EST 2020 | bk
Another thing you can check is where the bar comes down off of the hydra z motor there is a little bearing you can see from the front make sure that bearing is turning even oil it up a little. You can also adjust the tension by loosening the tiny set
Electronics Forum | Sun Apr 17 18:22:18 EDT 2022 | dekhead
Please clarify what you mean by "bouncing". Small up and down motions around home position? Full stroke of table movement up and down? Or somewhere in between? Does it start as soon as servo power is applied? Or not until table home movement is initi
Electronics Forum | Wed Aug 11 23:55:19 EDT 1999 | Dean
| | I appreciate you're input on this, John, Scott. It's a neat thing Mydata did with the power out, status saved feature. That comes in handy a lot down here. | The problem is with our machine, however, "I think", is that we have one of our phases
Electronics Forum | Wed Mar 29 16:25:55 EST 2006 | Tech
Find you a good degreaser to clean the clutches with. Fuji used to ship Threebond with the machines but quit due to negligence on the part of the users if I had to guess. I believe the number was Threebond 2706. Now make sure you take a shop rag or s
Electronics Forum | Wed Jul 18 09:22:12 EDT 2007 | ed_faranda
You're on the right track. 99% of the time, it is caused by a feeder not seating correctly. Check and ensure that all your tape covers are down and LOCKED (very important). Which type of feeders are you using Q or K? One thing I have found with K
Electronics Forum | Wed Sep 11 18:01:27 EDT 2013 | huske
I've had that issue before, here's how you fix it, or at least it worked for me. Also assuming you didn't destroy a shaft, which should be obvious. Follow the flexible vacuum tubes to the top of the hydra shafts, you should see a red light below the
