Electronics Forum | Fri Jul 15 16:16:56 EDT 2005 | fastek
Ah...but if MPM didn't mark up their parts like they do then you would be still working for them as a field service guy....instead of remarketing parts and machines.
Electronics Forum | Tue Jul 26 03:43:28 EDT 2005 | Rob
Hi Grant, We used to use Quicher automatic screw feeders - that basically present the screw for pick up to the driver - they worked very well. Let me know if you want any further info on this type of feeder as they may still be kicking around her
Electronics Forum | Tue Aug 02 04:52:16 EDT 2005 | aj
Crishan, You must be seeing an incredible amount of Attrition on this component if this is the case. You should most definitely be able to put in a Pick-up offset either at the machine or in the part data. aj
Electronics Forum | Wed Aug 03 10:48:48 EDT 2005 | Rob
Connectors, IC sockets etc. have traditionally use a lot of recycled plastic in them. There are no guarentees that there are no PBB/PBDE's in them, so some manufacturers are having to change back to new plastics. So plastic goes in the ground i
Electronics Forum | Wed Aug 03 10:03:25 EDT 2005 | Rob
There's always a used MPM UP3000, they're cheap.... ....but there is a very good reason for this.
Electronics Forum | Wed Aug 10 15:38:39 EDT 2005 | Field service
Yea right $ 600 becomes $ 6000. Ask them what they charge for travel? Is it actually the cost or do they mark it up a couple thousands. Let's be honest here.
Electronics Forum | Thu Aug 11 14:59:50 EDT 2005 | JDumont
Im hearing conflicting stories about the dreaded WEEE date. Does anyone have a up to date list? This is the best I could find... http://www.greensupplyline.com/howto/showArticle.jhtml?articleID=164302715
Electronics Forum | Wed Aug 17 10:58:47 EDT 2005 | Rob
Hi Allen, Thank you very much for your response, if anyone picks up the range in Europe I'll go & take a look. Cheers, Rob.
Electronics Forum | Mon Aug 15 21:01:46 EDT 2005 | grantp
Hi, Can anyone recommend a US based fast turn board shop that is very good, and can meet fast turn deadlines of boards with up to 12 layers? Regards, Grant
Electronics Forum | Wed Aug 24 18:38:04 EDT 2005 | bobpan
Sounds like a part problem with me too. I would suspect that something could be up with the leads. What do the joints look like under a microscope??? What do the part leads look like under the scope???