Electronics Forum | Mon Dec 12 13:11:16 EST 2005 | bobpan
Sounds like too much adhesive on the tape or static electricity. Try grounding the feeder if you think its not adhesive/tape related.
Electronics Forum | Mon Dec 12 15:14:05 EST 2005 | Rush Fan
Is anyone using this and have you had any luck reworking this material? It is supposedly reworkable but we have had no success using the "advertised" rework method. Any ideas are most appreciated.
Electronics Forum | Wed Dec 14 21:36:04 EST 2005 | davef
Dan Terstegge's jump site is the BEST. Look here: http://www.smtinfo.net/Db/_Wave%20Soldering.html
Electronics Forum | Tue Dec 13 07:51:23 EST 2005 | andrew1007
Dear sir , Help me ! Thanks a lot ! Regards! Andrew woo
Electronics Forum | Tue Dec 13 11:42:40 EST 2005 | excess_buyer
What are you guys and gals going to do with any stock that you have left over after the switch over?
Electronics Forum | Tue Dec 13 15:51:11 EST 2005 | Amol Kane
what part was this? was the high temp solder on the first level interconnect? why is the high lead solder being soldered with a SAC alloy?
Electronics Forum | Mon Dec 19 06:22:31 EST 2005 | Rob
Hi Grant, What sort of volume of 0402 resistors are you using - I may know someone who would put them on the larger reels.
Electronics Forum | Tue Dec 13 13:00:12 EST 2005 | chunks
Depends on the model, year and rev software you have. You can also move the SMEMA sensor into the oven a bit more too.
Electronics Forum | Tue Dec 13 13:01:24 EST 2005 | bobpan
We use a conveyor before our oven and put a footswitch on it to send the next board or jump the pins so that it just sends the board depending on delay needed.
Electronics Forum | Thu Dec 22 07:43:35 EST 2005 | grantp
Hi, That's true, and the plant just does not look high tech without that PC on the front of the wave. I should donate the wasted processor cycles to the SETI screen saver if it's still going on. Regards, Grant