Electronics Forum | Mon Nov 21 18:39:55 EST 2011 | khid
i've been in manufacturing for 15 yrs. I used AOI with match patter as well algorithm base in one machine. Easy to program, can built in global library based on your cspecs or part number use in the manufacturing line. ROI can be achieved in the shor
Electronics Forum | Wed May 04 21:32:30 EDT 2011 | jimlas53
Thanks for the answer, RLM, I couldn't find anything in the manual that was helpful. If I use a common extent for each component type, I need to identify those components that may be turned due to the feed type (tape, vibe). Is this where I would d
Electronics Forum | Wed Jun 08 23:03:47 EDT 2011 | grics
Can you massage the data manually? Extract the centroid data (file) from your P&P and either in notepad or excel perform the scrub then repaste to match the proper lines/columns in the csv file? Aside from gerber translation for new XY or identifyi
Electronics Forum | Wed Jul 20 03:10:45 EDT 2011 | umar
I have mount the 8 pcs SEVEN SEGMENT LEDS on the PWB side at SMT Process, after reflow the board test at customer side and facing some issues which is missing segment and also one segment founded dimmers compare to other segment. Data sheet of LEDs
Electronics Forum | Wed Aug 03 10:09:27 EDT 2011 | geb
Our Samsung CP45FV Neo is out of warranty, but due for its annual calibration/ service, however we are wondering whether it is really needed. The line only runs for 8 hours a day 5 days per week (including setup), so not heavy usage. The manual does
Electronics Forum | Wed Aug 10 15:45:49 EDT 2011 | franxsmt
Maybe I was not clear in my original post. So we have boards that have SMD components on one side and TH components on the opposite side. We want to assemble the boards using our SMT and Wave lines. Now the problem is that if we solder the SMD firs
Electronics Forum | Mon Aug 22 13:50:21 EDT 2011 | ryanr
I am looking for a methods to clean boards built with a "No-Clean" flux but the boards have non-hermetically sealed parts on them, therefore they cannot be exposed to an semi-aqueous process (what I typically use). These boards will be built in large
Electronics Forum | Mon Sep 12 05:43:53 EDT 2011 | aungthura
Hi All We have run the Hast Burn-in-Board into 2 soldering Process,first-Reflow and second-Wave. After wave soldering, there are many insufficient solder in the via holes.The via holes are wide as 15mil. Then, as customer's request, we have to cover
Electronics Forum | Thu Sep 29 09:16:17 EDT 2011 | mpolak
Hello, I have recently obtained a trial version of Mentor Graphics' BOM Explorer. Has anyone had any experience using it? We are currently editing our BOMs manually for P&P machines programming. After quick look and trying few options it doesn't see
Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine
We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our