Electronics Forum | Fri Mar 07 13:04:45 EST 2003 | gdstanton
Anyone out there have a source of information on the type of terms and conditions a subcontractor may use for a printed circuit card Build-to-Print job?
Electronics Forum | Tue Apr 29 12:18:01 EDT 2003 | jgregory
Pete, I have to disagree with your statement regarding 3D Xray not being a good source of determining solder volume. The Agilent 5DX is absolutely fantastic at determining volume. However, cost of the system makes it not very practical. Jason
Electronics Forum | Fri Jul 18 09:19:33 EDT 2003 | caldon
http://www.smtinfocus.com/dictionary.html The link above is a good source for a dictionary. good Luck Cal www.ctdi.com
Electronics Forum | Thu Aug 14 15:18:08 EDT 2003 | davef
All Potato-Bots need power. Look here for your source of potato powered power http://pbskids.org/zoom/phenom/potatobattery.html
Electronics Forum | Tue Aug 19 17:55:28 EDT 2003 | adlsmt
Anyone have a good source for respirators, gloves, aprons etc. for working on wave solder machines? Is there some industry standard for what is required?
Electronics Forum | Thu Sep 11 17:15:07 EDT 2003 | davef
We've seen two source of this: * Poor cure recipe [lookup 'microcanyon' in the fine SMTnet Archives] * Moisture absorbing glue formulations [lookup psi or aguayo in the fine SMTnet Archives]
Electronics Forum | Tue Sep 16 17:11:41 EDT 2003 | Stephen
How consistant is it? If it is every board try sending one through without the Tant. Don't overlook the possibility that the tant could be the source of the problem.
Electronics Forum | Mon Oct 20 15:33:18 EDT 2003 | severs
APS themselves is a good source for learning how to use this oven. Have you talked to them?
Electronics Forum | Tue Oct 28 10:45:22 EST 2003 | Gabriele
After following the suggestions above, and where it would not be possible to mask BGA by soldering fixture, a Kapton tape (pre-punched) can be placed under BGA ( wave solder source side ) it can help to keep temperature low enough avoiding "seconda
Electronics Forum | Wed Dec 17 13:04:37 EST 2003 | Bill
Thanks for the information, --We would like to replace the conveyor 'belt' rather than replace the whole conveyor. Do you know of any sources for the belting material? (ESD, heat and chemical resistant) Best Regards, Bill
World Equipment Source has over 20 years experience in Electronic Assembly Equipment. We will resell your equipment by utilizing our global market of associates.
Equipment Dealer / Broker / Auctions
8655 Production Ave Suite B
San Diego, CA USA
Phone: 858-693-1991