Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Fri Oct 02 10:34:20 EDT 2015 | dyoungquist
After looking at your profile, some general thoughts.... Your profile looks like what is commonly called a ramp-spike profile and not a ramp-soak-spike profile. Going off of Sarason's comment, you may not have a good soak period before the spike in
Electronics Forum | Fri Nov 06 12:15:19 EST 2015 | derrikf
Also, for anyone who's taken an interest in this thread: We just received samples of Henkel/Loctite's room temperature stable(yes, you read that right), halide-free, lead-free pastes, both the GC 10 and the GC 3W (which is a water soluble/wash paste
Electronics Forum | Wed Sep 02 20:18:18 EDT 2015 | sarason
Are your PCB's stretched or is it that the films that were used to make your PCB's distorted.Thus vias and TH's don't align. These things will probably be picked up in bare board testing , but depending on the amount of offset may get through, to yo
Electronics Forum | Fri Sep 18 13:11:38 EDT 2015 | dyoungquist
We used to run a TP9-2 but upgraded to the MY series about 5 years ago..... Encoder going bad is a likely possibility, especially on a machine that old. I can't say for sure that is your problem but we did have to replace an encoder on our TP9 (I
Electronics Forum | Tue Oct 06 14:29:14 EDT 2015 | cadco
Update 6 Oct 15: We have completely re-configured the oven PID boards such that everything is now visible on the oven by the s/w and all is now OK since the "Machine"card is now recognized. We have just one additional procedure to do and that is to
Electronics Forum | Fri Jan 08 03:56:38 EST 2016 | a290668789
there is no best company just the company best for you. E.g. I use PCBgogo(www.pcbgogo.com/b), they make PCB and also do PCBA, but they don't buy components for me. I don't like this at first and I prefer turn-key service, but why I still choose them
Electronics Forum | Mon Nov 02 23:01:59 EST 2015 | dan59314
RvConverter AOI/AVI CDR tools free download Users Manual: http://www.rasvector.url.tw/RvConverter/RvConverter使用手冊.pdf Easy to use : Generate AOI data in just 2~3 steps. 1. Load File. 2. define Output Region/Resolution(Optional)
Electronics Forum | Wed Jan 03 02:23:05 EST 2018 | michelle01
We now offer free expedite for PCB prototype. > Min $5 for Standard 1-2 layers board > with 24-48H lead time Min $34.78 for > Standard 4 layers board with 48-72H lead > time. We think it should be very helpful for > your projec
Electronics Forum | Sat Dec 12 08:34:59 EST 2015 | jfeustel
Tom, we are in the Chicago area and we deal extensively with used Universal Instruments equipment. I probably have just about anything you might need for an older GSM in stock. I agree with Deni in that I would match a replacement hard drive very cl
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
