Electronics Forum | Thu Nov 08 08:44:22 EST 2007 | aj
Hi, I have just taken a look at the Connector Images. Is there a difference in pitch between both connectors ? From the photo it looks like the Annular Rings are oversized on Image #1 especially around the centre area ( this might be the image ).
Electronics Forum | Thu Jan 10 11:37:43 EST 2008 | jdengler
Hi JD, We use the OM-310 NC for most of our lead free work and see some wetting issues. We also have a lead free produst that requires cleaning so we use the WS-819. It does seem to wet better although I have never tried the WS-819 on the same b
Electronics Forum | Wed Feb 06 15:51:26 EST 2008 | jax
We have place CSP devices with 0.105mm standoff hights without any issue. The ability to Water Wash all depends on the specifications of your wash... Spray pressure and qty of jets Dwell time, pre-wash/wash/rinse Available detergents or saponifiers
Electronics Forum | Thu Feb 14 07:34:10 EST 2008 | jdumont
How many fell off out of your entire lot? What was the soldering quality like on the ones that didn't fall off (xray, visual)? You need to determine if its a random problem or if even the ones that stayed on are barely on and go from there. If the o
Electronics Forum | Wed Mar 05 17:03:36 EST 2008 | ratsalad
We had the misfortune of ending up with a batch of Kester EM907 that would start to "set up" well before it's shelf life was over. Since the lead time for a new batch was excessive, a Kester technical guru came to our facility to help us deal with t
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the
Electronics Forum | Wed Mar 26 09:19:20 EDT 2008 | nibirta
hi all...well i`m working in such a lab but we are working internally, and for our customers. But i can give you some prices from other labs. Cross section-one location is around: Solder Joint Integrity Std. sample plastic package $300.00 Shorts /
Electronics Forum | Thu Apr 10 07:47:47 EDT 2008 | ck_the_flip
Stencil design and pad layout are key. Too far apart - bad. If your pad geometry is correct, try the inverted home plate. That has worked well for me in the past. That, coupled with a 5-mil stencil. With regard to solder paste, some manufacturer
Electronics Forum | Wed Apr 30 12:26:10 EDT 2008 | dphilbrick
There must be discussions about this on SMTnet but I have yet to find them. I would like to hear from all you smart people about running LF and PB BGA�s on the same board using 63/37 solder. If you run your profile up to peak at around 225C +/- (nitr
Electronics Forum | Tue Sep 16 09:35:12 EDT 2008 | babe7362000
Can anyone tell me if there is a procedure for storing raw PCB's? We currently are seeing an issue with lead free boards with dewetting. We tracked it down to one or two datecodes, but not all of the boards have dewetting. Is there a expiration da
