Electronics Forum | Fri Sep 20 05:17:10 EDT 2002 | byates
What are the error codes?? you dont even know if it is the vision type until you have checked this out. It could be camera lighting. Do you know how to use vision trace on your machine? What is your x&y tolerance? What about vision 254 or 255 have yo
Electronics Forum | Wed Jul 16 10:55:08 EDT 2003 | stepheno
You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want
Electronics Forum | Tue May 24 05:21:32 EDT 2005 | Zsolt
did you try it with different product/programs? if not, then please try. It could be a mistyped placing position also. Is there any error code? Could be several reasons but I think servo amplifier or servo motor could be the cause. More info would be
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Mon Jun 05 22:40:40 EDT 2000 | Dean
...well, if I had Fuji in on 4 occasions and the problem is not resolved I would wonder what exactly I paid for... Here is what I would do. 1. Run the glass plate program. This will eliminate variables in your production parts and boards. Additi
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Wed May 27 16:39:33 EDT 2009 | rmitchell
Hi, I think vision 20 will work as well. If not we have used 100 or 105. Have you tried placing the part with the machine trace on? If so is it finding all the leads? any error codes? If you are defining the leads in the EL lead data I would not d
Electronics Forum | Sat Jan 20 17:41:11 EST 2007 | bvdb
Hoping someone can help us. Our Fuji IP-1 won't boot up unless we disconnect the 25 pin RS232 connector that runs to the MCS16/F programming computer. It doesn't matter if the 9 pin connector on the other end of the cable is plugged into the MCS16/
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo