Electronics Forum | Fri Jul 26 11:20:33 EDT 2013 | gnus
Hi all, I'm having issues placing 7 pin DPak packages. I'm using mechanical centering with four centering phases (one for each orientation). Tool used is A24S. Machine picks up the part but will reject it when centering the part. I have measured all
Electronics Forum | Thu May 01 07:39:21 EDT 2014 | pfifla1
Frazzled - It's not just you. Regardless of the price the machine is when a service engineer comes to your place they should have 95% of the tools needed. now a 24" crescent wrench might be hard to tote around but all the standard tools should be wit
Electronics Forum | Thu Aug 05 17:37:28 EDT 2021 | SMTA-64387687
Did you grease the tool o-rings? If they are too dry, the head won't slide onto the tool. Also, make sure the tools are flat in the tray. I'm assuming that you aligned on the center of the tool. And, try cycling the non-spring tools, like A24, to see
Electronics Forum | Sun Aug 21 15:35:22 EDT 2022 | zadir
good afternoon, please tell me, maybe someone has encountered a problem on the juki 730/740 machine.we have a 24 volt 10 amp power supply broken on it (it stopped turning on completely) we changed it, but now stanou can't find the zero point, he come
Electronics Forum | Tue Oct 03 18:09:06 EDT 2023 | glasscake
Try a liquid latex masking material. Youll most likely have to cover the hole with kapton, really drench the thing in the liquid latex to prevent the ultrasonic from damaging it then bake it at 50-70c for about 2-4 hours. With no bake its usually a 2
Electronics Forum | Mon Aug 14 01:49:14 EDT 2000 | Joe
G'day, I am interested in hearing about the automatic lubrication of the chains in a reflow oven. The systems I have seem to work to a certain degree. They either lubricate too much, so we end up getting oil on the edges of the PCB, or not enough, w
Electronics Forum | Wed Dec 05 13:19:23 EST 2012 | markcsi
We have an SMT-5000 that we have been using for many years, but up till now the smallest device was SOIC, SOT23 type devices. Now I have designed a board that has a 24 pin TQFN-EP device and a 10 pin LFCSP_W device. I am concerned that this is be
Electronics Forum | Mon Oct 16 16:05:59 EDT 2000 | CAL
Brian- IPC has SMEMA Down loads for communication protocal: http://www.ipc.org/html/fsresources.htm. Also, I interfaced a fuji CP6 with a Siemens s20 and had to put in a relay and sensor to complete the communications loop. Fuji uses a 24v on/off com
Electronics Forum | Wed May 19 16:57:08 EDT 2004 | ricardof
We have in our facilities in Mexico more than 150 FUJI machines (CPs, IPs, QPs, GPs), they're in fact Bombproof, but it is not amazing to do that with 1206, SOTs on SOPs, we just feel a kind of disappointed with that 10K hours service, that means yo
Electronics Forum | Thu Jul 27 08:02:55 EDT 2000 | Jason
Hello once again! I am having a problem with a 24 pin connector bridging on the wave. We use very similar connectors on other PCB with zero problems. This connector bridges in the same place on the same pins. It forms like a little block of four