Electronics Forum | Tue Mar 23 02:32:23 EST 1999 | Bob Willis
| | Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of t
Electronics Forum | Wed Mar 24 02:23:14 EST 1999 | P.L. Sorenson - Technical Consultant
| | | Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of
Electronics Forum | Thu Sep 16 09:29:13 EDT 1999 | Rob Jankowski
| | | Looking for a manual machine to de-panel with the panels held by 60mm tabs. Each panel hold multi-boards consisting of different shapes and sizes. Scoring is apparently not an option and volume does not dictate a large scale machine. | | | |
Electronics Forum | Thu Sep 16 09:31:05 EDT 1999 | Rob Jankowski
| | | | Looking for a manual machine to de-panel with the panels held by 60mm tabs. Each panel hold multi-boards consisting of different shapes and sizes. Scoring is apparently not an option and volume does not dictate a large scale machine. | | |
Electronics Forum | Tue Sep 01 15:37:25 EDT 1998 | Ben Salisbury
| How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks Matt- Find some fairly stiff wire, the correct gau
Electronics Forum | Sat Oct 05 07:29:48 EDT 2002 | davef
Design for the Environment (DFE) / Electromagnetic Compliance (EMC) ------------------------------------------------------------------- "Noise Reduction Techniques in Electronic Systems" Henry W. Ott, John Wiley & Sons, New York, 1976 Seltzer, G.S.
Electronics Forum | Thu Nov 12 11:16:55 EST 1998 | Dave F
| | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | Dou
Electronics Forum | Fri Nov 13 10:25:11 EST 1998 | Doug Clement
| | | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | |
Electronics Forum | Mon Mar 22 16:59:15 EST 1999 | B K
| Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of tim
Electronics Forum | Tue Feb 03 16:42:50 EST 2009 | cuperpeter
Hello All, > > I have a problem with nonwetting Au > finish after second cycle of reflow soldering > doublesided boards. Solder nonwetted pcb pads (is > wicked to component terminations) Either these > pads or some of non component pads became