Electronics Forum | Wed Dec 20 14:30:07 EST 2006 | Polynesian Pebbles the Joker
Hey pr...sure it's warm there, but I also hear that in that area where you live it's not too uncommon to have a kiddie pool in the front yard (with a couple of darkies in there), pickup truck parked on the front lawn, chain-link dog jails, with you o
Electronics Forum | Wed Aug 13 09:20:05 EDT 2008 | wrongway
we tested this kind of part about 3 years ago did a few prototypes I did'nt know how it was going to work but our old amistar picked it and placed it just fine used a small nozzle with a o-ring on the end of it I think it did ok going across the wav
Electronics Forum | Tue Sep 29 11:37:52 EDT 2015 | robl
Hi Marlyn, We use durastone pallets over a wave - so areas machined out so the solder can get to the pins but not the SMT. You can also get fancy selective solder machines, but I'm guessing that as you're asking you haven't got one. Hope that help
Electronics Forum | Wed Mar 10 11:43:11 EST 2004 | Bill Aldeen
My name is Bill Aldeen, and I own and operate Nu-Way Electronics, Inc. We provide Tape & Reel packaging service for surface mount and through-hole electronic components. We're in the Chicago area, and we serve all of North America competitively. W
Electronics Forum | Thu Mar 03 11:49:23 EST 2005 | Rob
Doesn't that depend on your company's culture & management style? We (and I feel slightly dirty using this word)empowered our end of line inspection/touch up people & trained them to know what is good or bad - so issues can be immediately fed back,
Electronics Forum | Fri Jan 27 16:50:22 EST 2006 | patrickbruneel
GS I am not a lawyer and the European directive has a lot of grey areas. But if you look at 1.2 in the link I send you it states that when an appliance can still function when the electrical current is off this type of equipment is not covered by di
Electronics Forum | Sat Jun 03 03:35:16 EDT 2006 | mika
Yes we do have a problem with this. We have by now investigate numerous lead/RoHS PCBA:s The RoHS boards are by far the most difficult one's to probe and test. Our people at the "test area" including Flying Probe and ICT they spend a lot of time to t
Electronics Forum | Fri Aug 18 11:01:52 EDT 2006 | Frank R.
Hi, We have two complete SMT line and in this department we use conveyors for board manipulation. Concerning the wave area we are not full efficiency and I have to look for conveyors and bar code reader to make board manipulation an automatic proces
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
Electronics Forum | Wed Mar 12 12:28:52 EDT 2008 | operator
I recently witnessed a process in which the solder pot operator used Techspray WSOL water soluble masking to cover the areas around a connector that was to be soldered on the solder pot. He did not wait for the WSOL to cure. He soldered immediately.