998 capacitors and pick results

Electronics Forum: capacitors and pick (Page 3 of 100)

Resistors and capacitors 01005 measurement of value

Electronics Forum | Wed Jan 30 03:20:00 EST 2019 | bane016

We measure each first board before the oven after every chageover...Assembling one offset and measure component, after we clear plate...We have reason why do that...But we're wasting a lot of time.So I wanted to see how you do it. Thank you for answe

Selecting pick and place machine (comparison/personal experience/sales pitches)

Electronics Forum | Wed Apr 28 20:57:22 EDT 2021 | stephendo

It will be tough to get a good line for that cost. You might want to start by looking at Mydata and Juki for the machines. Ekra for the screen printer and Heller for the oven is where you might want to start. If you have not already you might want

Need low cost pick and place machine for limited production

Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose

Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc

CSM-84 pick and place machine.

Electronics Forum | Sun Feb 13 16:28:00 EST 2011 | tpappano

Does nozzle #1 lower at all when it should pick up a part or is it just staying in the fully up position? If it does come down, but not quite far enough to contact the part, there are adjusting nuts on top of the head that set the lower limit for no

Samsung pick and place machines

Electronics Forum | Thu Jul 27 15:34:48 EDT 2000 | Craig

Does anybody know much about or had any experience with Samsung pick and place machines, in particular the CP45FV, CP40L and LV. They seem a cheaper option, but apart from the agents we cant find anyone with much to say about them.