Electronics Forum | Thu Nov 15 10:33:35 EST 2007 | paulallan
Does any one know of a supplier high temperature PCB ink that can safely used between pads on an SMT connector. The product ideally should be screened on and have resistant to short exposure to heat from a selective lazer. Must be non-conductive and
Electronics Forum | Tue Jun 29 04:45:10 EDT 1999 | Earl Moon
| | Hey there gang, how's it going ? | | | | Anyway's here's my probelm, got a new product to build double sided reflow, lot's of so20's and PLcc's 1206's, 0805's the usual stuff. Probelm is all the pad spacing of the 1206's are too big, my componen
Electronics Forum | Wed Feb 26 04:28:39 EST 2014 | chongns
Hi All member I have a problem on the stable down the color of the white solder mask PCB. first, i tough the color differences was cause by the solder mask ink, but after a close look, the color change are cause by the copper under the solder mask
Electronics Forum | Wed Mar 10 17:03:52 EST 1999 | Morziana Hasan
NASA CommQuest Photopolymerized Conducting Polymers Directions: 1.Please read the information provided on this technology. You may follow the links to additional information resources below. 2.After evaluating the technology, please answer the
Electronics Forum | Mon Dec 23 17:36:23 EST 2002 | davef
Periodically, we get ahead of ourselves and find that we have fabricated boards that require jumpers and other modications. Alternatives are: * Add 'white wire' jumpers and mod the components as third ops * Print, cure, and seal 'jumpers' of epoxy i
Electronics Forum | Wed May 03 15:00:44 EDT 2006 | patrickbruneel
It all depends on process, design and environment in which the contacts are used. Both have excellent conductivity characteristics Both don't oxidize over time On the other hand gold is much softer then carbon, and after hitting that contact a gazil
Electronics Forum | Tue Apr 23 15:36:27 EDT 2019 | davef
Josh, are you setting someone up with these questions? Answers to your questions related to the subject line follow: Q1. Does the Epoxy Solder Mask Layer of a PCB protect against moisture absorption? Is this a primary function of the solder mask?
Electronics Forum | Thu Aug 10 13:12:10 EDT 2000 | Bob Willis
You may care to review the following from my Circuits Assembly page on line. "HOW FLAT IS FLAT AND DO WE NEED FLAT CIRCUIT BOARD, YES WE DO ? As production problems go there is one that keeps reoccurring time and time again. The blame is usually di
Electronics Forum | Mon Jun 08 14:52:16 EDT 1998 | Gary Simbulan
| Earl, et al, | Boy things get old and cold around here fast. I promised more detail on my capactior problem and I thought I could drop something completely different in the same message and tell a tale of solder balls. | First the caps. We stil
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo