Electronics Forum | Sun May 23 11:02:45 EDT 1999 | M Cox
Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them out with
Electronics Forum | Thu Dec 05 11:36:30 EST 2002 | William Guatemala
Have you check the flux gravity lately? If not, Check the flux gravity every 6 hours to make sure proper parameters are meet. Here is a list of things that may cause your solder ball problems; Excecive heat, defective fixtures, preheating temperature
Electronics Forum | Sun Jun 21 02:43:27 EDT 2020 | jmelson
I'm planning to upgrade my P&P. We had a local auction that included a Samsung CP45FV. I was able to download a NEO manual, it was very well written and the Samsung software looks just incredible for setup and programming the vision system. But, t
Electronics Forum | Sun Nov 07 10:54:21 EST 1999 | Steve Thomas
We're looking at redesigning our stencils to facilitate better (well, it's pretty much non-existant, so any improvement is a big leap) release from fine pitch apertures. Currently we have perpendicular walled laser cut apertures. We'll be having
Electronics Forum | Wed Sep 18 12:31:16 EDT 2002 | dragonslayr
My suggestion is to conduct a Design For Manufacturing (DFM)study on the assembly in question. Pay particular attention to the pad sizes, component lead dimensions and satisfy yourself that those two factors are correct. Given that pads match compone
Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Fri Oct 28 04:56:12 EDT 2016 | lilybell
I read a few posts here about resistor in led applications. The thing is, the resistor has clarified as this shows:was always use with a power source delivering a higher forward voltage than the led could tolerate(ex: a 9volt battery hook up to a 3w
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Thu Apr 07 09:04:19 EDT 2011 | mosborne1
First of all you need a new board house. You should quote us http://www.americancircuits.com. This really looks like a poor drilling operation with the blow holes. Blow holes are usually caused by two main problems. Improper drilling and/or moisture.