Electronics Forum | Tue Feb 08 07:11:24 EST 2005 | teilo
We manufacture all titanium component parts for wave solder machines. For additional information on our products please visit our websit at http://www.teiloengineering.com
Electronics Forum | Tue Jan 17 10:00:19 EST 2006 | alandra516
Contact me I have both mauals that you need glenn@alandraservices.com
Electronics Forum | Tue Jan 17 10:09:03 EST 2006 | pjc
I will send an engineering data sheet to your e-mail address. I do not have a manual, check with these guys: Tom or Dennis (603) 437-4755 Ed Fortuna (603) 759-2953
Electronics Forum | Wed Jan 18 02:08:11 EST 2006 | meritajs
Dear Pete C, If it is possible please send this engenering sheets to us e-mail:altonteh@tl.lv Thank you and best regards Peter
Electronics Forum | Thu Jan 11 12:42:55 EST 2024 | richardcargill
if the battery failed then you will have lost all the Cmos settings it held relating to the disk drive configuration/availability. Jump into the PC setup at switch on and make sure everything is correct
Electronics Forum | Mon Dec 12 13:34:15 EST 2005 | jbrower
Hi Frank I use an electrovert econopak and am very pleased with it. Electrovert offers a leadfree upgrade to the pot but it is a might bit expensive. Contact them for pricing. In my machine I am going with SN100 distributed by AIM. It might be some
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Wed Dec 21 06:51:48 EST 2005 | aj
Hi all, I have an Electrovert Econopak Plus wave solder machine. Lately the solder pot temp has been fluctuating +/-10 degrees c. I have replaced the thermocouple as I suspected it to be faulty but the problem still exists. I am confident that the
Electronics Forum | Mon May 15 08:53:52 EDT 2006 | aj
Hi All, Due to carry out the Bath Changeover this weekend. I have an Electrovert Econopak- 550 kg bath. We are not replacing our internal components i.e nozzles/pumps etc. until we really have to. Has anyine carried out there changeover yet and ha
Electronics Forum | Tue Mar 11 11:52:06 EDT 2008 | edmneb
Anyone know of a place to get a replacement pot for an Electrovert Econopak II SMT? Preferably a titanium pot? We currently have a machine that is running SN100C and it seems to be developing some pitting in the metal of the pot. We would like to
