Electronics Forum | Fri Aug 22 15:27:13 EDT 2008 | wayne123
this is the order that I use. 1. Teach pcb origin 2. Teach fiducial location 3. dial in vision on fid in mark info. 4. go into mount and verify that the primary image is on in x/y (after perfoming a teach trace condition) and then do any offsetts if
Electronics Forum | Tue Nov 18 21:11:26 EST 2014 | sonavc
THANK let me change in PD and see the result
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
Electronics Forum | Tue Nov 11 13:25:17 EST 2014 | jimmyboz
I do not recall that "TEACH" ever worked. Even if it did, there is no way to save this data to the MCS. After you see that a fiducial cannot be found, change Xa-Ya in the program at the MCS to find it, and of course, re-transmit. Good Luck
Electronics Forum | Wed Nov 19 10:57:55 EST 2014 | jimmyboz
Oh yeah, You can flip to switch on the camera card, VM1710 and jog the PCB under the fiducial camera to visually inspect to placements. switch it back when you are done.
Electronics Forum | Mon Nov 10 23:14:25 EST 2014 | peteb
Do you have the correct keyboard? Are all of the keys accurate for MCS?
Electronics Forum | Sat Nov 08 21:48:42 EST 2014 | sonavc
ETC then you see TEACH. But I can't see it. Do my machine need to update the software or chane some thing in the Proper program?. I'm using MCS16 computer. So far the machine runs great , But take me awhile to move to correct fiducial location Thank
Electronics Forum | Tue Nov 11 21:21:54 EST 2014 | sonavc
Thank you, that is help, I always change in program and re-transmit. One more question, I program N_data with capacitor is TANTB (using M nozzles in part data). but when I run the program in machine it is always use S nozzles to pick the cap. TANTB
Electronics Forum | Thu Nov 13 13:12:57 EST 2014 | jimmyboz
Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.
Electronics Forum | Fri Feb 17 22:48:47 EST 2006 | bvdb
Thanks Jerry - I'll try it on Monday. Cheers, Bert
