Electronics Forum | Thu Apr 28 08:29:22 EDT 2005 | andymackie
If what you are talking about is "assembly materials", then consider the following: - Solder paste - Wavesoldering fluxes - Bar (for filling wavesolder pots) - Underfill (for TCE-mismatched CSP's and flip-chip) - Cleaning fluids (for post-reflow boa
Electronics Forum | Mon Feb 13 10:33:57 EST 2006 | fredericksr
Hello, I am automating a process on our floor from wire solder hand application to dispensed paste and reflow. The process involves "lidding" a shielding lid around our assemblies for microwave quieting. The result is non-hermetic. For cosmet
Electronics Forum | Tue Feb 03 13:39:08 EST 2009 | grics
Good morning Jamie. I work at a CM and can offer some input on process flexability. I do not have any data on how reliable the coating is but I can say that they are both very difficult to control. Will you be selective coating or full coating? Ho
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408