Electronics Forum | Sat Jul 30 05:50:02 EDT 2016 | sarason
Loose grub screw on a sensor or rotation motor shaft ? sarason
Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Mon Jul 10 16:37:10 EDT 2006 | mac
Hi All, Lately we have been getting a humming noise which seems to be coming from one of the D-axis motors on the CP4. If it happens the Op. hits the e-stop and resets the machine which clears the noise and machine runs fine. Obviously there is a
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Mon May 09 17:49:28 EDT 2005 | chon
Inspect the cables specially in those area where cables have bendings with the motor motion. If they have something covering them or extra insulation try to remove it and inspect closely. If the machine runs and suddenly stops with this error and aft
Electronics Forum | Tue May 24 05:21:32 EDT 2005 | Zsolt
did you try it with different product/programs? if not, then please try. It could be a mistyped placing position also. Is there any error code? Could be several reasons but I think servo amplifier or servo motor could be the cause. More info would be
Electronics Forum | Thu Mar 30 14:00:32 EST 2006 | jdengler
Hi Bert, There should be an action occuring when the machine hangs-up(ie: Q motor rotating, getting ready to change nozzle, or other action). See if you can find this. The first thing that comes to mind is a loss of the signal for a nozzle in the
