Electronics Forum | Wed Jul 29 17:33:39 EDT 2015 | mikekeens
What adaptable PCB support system do people recommend for use in pick and place machines when processing double sided assemblies? - Grid-lok, vacunest, red-e-set?
Electronics Forum | Mon Jan 06 16:58:45 EST 2020 | cbeneat
I would recommend quik-tool. Jim Bernhard essentally the inventor of Grid lok left when they went to DEK. Started quik-tool, we use grid-lok in our printers, quik-tool in our Panasonic P&P instead of support pins. Like quik-tool alot more. JBernhard@
Electronics Forum | Tue Jan 23 15:20:59 EST 2007 | stepheniii
On the Ekra those are called top clamps AKA finger slicers. With the Ekra side clamping means there is nothing on the top of the board. Does your printer have true side only clamping? Or do you need the top finger slicers for the grid-lok to work r
Electronics Forum | Thu Nov 06 13:34:30 EST 2003 | moncav
Hi John, Please check out http://www.grid-lok.com This is an automatic and compliant tooling system that may eliminate your need for custom tooling. Grid-lok has a rep in your region. Good luck, Charlie
Electronics Forum | Sat Feb 14 20:33:08 EST 2004 | Dean
Grid Lok is the best. http://www.grid-lok.com/ Well worth the money. Outstanding support under the pcb.
Electronics Forum | Wed Nov 17 17:27:01 EST 2004 | jimbernhard
Megan, I know that Ovation Products will send Grid-Lok's out for evaluation. They also sell used and demo systems directly. You can contact them from their website at http://www.grid-lok.com Hope this helps. Good luck with your evaluation
Electronics Forum | Fri Nov 09 15:52:47 EST 2007 | kmakiya
We have been using Grid Loks on our MPM Accuflex machines and see an offset in the print every so often. Haven't been able to isolate the problem. How bad was the misprint and how was it related to the grid loks? Thanks
Electronics Forum | Wed Jan 24 11:22:46 EST 2007 | pr
Do you still have the vacuum plates in? If so, you can set the grid-lok up in the "fixed mode" (not sure what they call it,where it won't set for each board), then you could run without side clamps and the Vacuum should be enough to keep it from movi
Electronics Forum | Wed Jan 29 08:32:48 EST 2020 | dontfeedphils
I'm currently running Grid-Lok in my printer and have used it almost exclusively in the past. That being said, I'm looking for a solution to help correct/remove sag and warpage on PCBs that will run through our TRI SPI and AOI. I have no doubt th
Electronics Forum | Tue Jul 31 09:36:42 EDT 2001 | Cherry P.
To expand a little the question above...Can you give us the specific results of your research and development testing?
.gif)
.gif)
.png)
winsouce.jpg)