Electronics Forum | Tue Oct 21 22:42:50 EDT 2008 | fujiphil
What error displayed after the vision process? If all the parts processed at Head 1 did not pass the vision, try to adjust the scan speed of the camera1. kindly send the error code. Jep
Electronics Forum | Fri Sep 03 08:42:01 EDT 2010 | naveed
hi!i have the disc labled mechine software and another labled upgraded software.but i dont have the procedure,or any sort of training regarding this.i got training from my teacher who visited japan trainig schdule,but for last 7 years i am doing all
Electronics Forum | Mon Sep 20 15:32:27 EDT 2010 | naveed
Yes!tahnkx I made a backup disc.the all data for production files,and also the data base library(vision files for component and fiducials) has been copied to the disc.we are in contact with yamaha consultant,they sent us the new manual which has the
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Sat Mar 11 07:33:52 EST 2023 | klauss
There's two kind of nozzles with different dimensions we use. One of them works good but the another one gives a head problem sometimes. The head picks the nozzle and gives the vacuum error despite the camera recognize it. So i make another head pi
Electronics Forum | Tue Jan 16 02:31:19 EST 2007 | meritajs
The problem is that if we disable center head and even turn off the cable of center head encoder, it's not helps. The same error appears. And it's all the same it shows error of the center head.
Electronics Forum | Thu Jan 11 05:58:35 EST 2007 | Peter
Hi All, We again have problem with Zevatech FS-730 This machine shows error E202162: "System error: T axis of center head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low spe
Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp
Electronics Forum | Mon Nov 19 17:43:16 EST 2012 | jaimebc
Theta error came back again during our first production run. Swaped motcards as a final attempt to find an easy fix and nothing. I swapped heads with another MYDATA to positively isolate the problem. And the theta error followed the head.