Electronics Forum | Sun Nov 25 09:20:38 EST 2012 | mgjme
We use JUKI KE2060 now, and we consider purchase of two YS12 for our next assembly line. But I'm afraid some of the details, like lack of pick-hight measurment function in YS12, we got used to perform at the begining of new production run (by JUKI's
Electronics Forum | Thu Oct 03 17:11:11 EDT 2019 | billastle
Hi, Let me see if our Juki applications team has some suggestions. Our general table based up-look vision will work also, but will be slower than in flight laser align. Do you have a general email we can reply to with details and specifics on the
Electronics Forum | Mon Feb 16 01:26:30 EST 2004 | Frank
The 575 was based on the 570 machine. The 570 was Juki's first laser centered machine. It can do 0402 and ICs with a pitch of 0.65mm or greater. The 575, was a re-vamped 570 that Zevatech came up with. Juki played no part in the 575. Zevatech ad
Electronics Forum | Tue Nov 08 22:49:41 EST 2022 | jojoled
Hi, I need help with placing 0402 resistors 90% of them are picked correctly, but are not placed(thrown away) giving me error : LASER retry over. Slightly higher varistors in same package have slightly better placing rate, about 50%, but still not su
Electronics Forum | Wed Mar 21 09:57:06 EDT 2007 | charles
Hi friend, Can be possible with 1st & 4th head. But if you want do vision test , it is impossible. Only laser test , yes it could be . If you want to do vision test, you have buy Ke2060 with MNVC option.
Electronics Forum | Tue May 14 16:59:24 EDT 2013 | leeg
Cheers again. So if the bga is 1mm thick and with the balls 1.3 mm thick I should set the component height at 0.9 to be sure of cotrectly centering on the body ?
Electronics Forum | Tue Jun 18 09:02:02 EDT 2013 | leeg
We are having issues on our 750 machine with the following errors, E240015 and E240021 this can occur on any of the 3 heads therefore surely ruling out Laser issues with 1 particular head?
Electronics Forum | Sun Dec 21 23:30:09 EST 2014 | sarason
Since the Laser alignment bit is attached to the head and you don't have to move the part to a camera location, before placing the component on the board it is about the fastest method there is of getting accurate component alignment. With more moder
Electronics Forum | Mon Nov 09 03:42:50 EST 2015 | robl
Hi, we use Eric from QY in China for repairing our Yamaha/Assembleon and Juki Lasers. We must have sent 15-20 in the last 2 years and they do a good job. Contact details: sales@qy-smt.com Hope that helps, Rob.
Electronics Forum | Sun Jun 17 23:04:16 EDT 2018 | jandon
Nice! Place it in jig holder larger holes upward and start calibration. This calibration block is only for the laser heads. Calibration block E5190729000(white dot in the middle of the block) is also for the camera.