Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799
I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and
Electronics Forum | Mon Mar 05 15:24:41 EST 2007 | Hussman
Well, there you have it Pavel, Tim says to switch to DEK. Start packing up your MPM.
Electronics Forum | Mon Mar 05 22:55:05 EST 2007 | valuems
they cost 35 or 36 hundred dollars from mpm. And if the board are thiner then 20 thousands in thickness, lots of luck.
Electronics Forum | Tue Sep 22 11:25:40 EDT 2009 | jorge_quijano
I'm not pretty sure if this is what you need, It is for a UP2000, hope this helps. JQ
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
Electronics Forum | Mon Mar 05 14:44:51 EST 2007 | daxman
Hey, I've seen a lot of AP25's with snuggers. I don't know if they all came with the pneumatics or not..but if you have the snugger reg. guage, just underneath the Z table, you should be okay. The fellas at goppm (www.goppm.com) have a lot of knowl
Electronics Forum | Tue Mar 06 06:34:13 EST 2007 | pavel_murtishev
Good afternoon, We use both brands. Speedline�s latest printing machine generation is as good as DEK. It�s my humble opinion only. But AP 25 vacuum support system starts to fail even with fine pitch. Thanks for your input anyway. BR, Pavel
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
Electronics Forum | Wed Oct 28 13:29:11 EDT 2009 | swag
Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.