Electronics Forum | Tue Oct 09 10:28:48 EDT 2012 | swag
Awesome! Glad to help.
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Mon Feb 27 13:33:03 EST 2006 | Robert
Our MPM 2000 screen printer machine has a problem. During the machine reset mode a warning message come up "Z lockout not operating". Does anyone know what fault could cause this?
Electronics Forum | Tue Mar 07 00:11:30 EST 2006 | jgarver1
Is this a new machine to your facility? I have seen MPM UP3000's give error while homing if the transformers are not tapped exactly at the line voltage. Just a thought.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Mon Jun 19 15:13:42 EDT 2006 | Chunks
There is also plastic link on the shaft that raises your Z-Table that may have come lose or broken. Is the Z-Table able to move up and down in Supervisor mode?
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Wed Apr 03 03:19:37 EDT 2024 | ddfreeze
boots with cmos battery low message. I do not see a battery anywhere to replace. F1 utility does not seem to work. hard drive is good. do not have an A: boot disk
Electronics Forum | Fri Apr 05 01:25:14 EDT 2024 | ddfreeze
My research taught me that most older 486 motherboards have a similar CMOS substitution chip that you can purchase, or modify the one you have with a battery as shown.