Electronics Forum | Thu Oct 27 12:58:33 EDT 2005 | gregp
EIA-481-B Max tape thickness 1.1mm (not including bottom and top cover tapes which can be .1mm max each) Of course a 1.1mm thick piece of steel will be stiffer than a 1.1mm thick lasagna noodle (already cooked). Is the thickness the issue or is it t
Electronics Forum | Wed Oct 26 10:21:28 EDT 2005 | russ
We are also experiencing problems with this thick stiff paper tape. Our problem is the strength of the spring that supports the tape at its pick position. After a while it just pushes it down because the tape exit wants to bend the tape too sharply
Electronics Forum | Thu Oct 27 09:23:36 EDT 2005 | rlackey
Hi Russ, Kemet - http://www.kemet.com/kemet/web/homepage/kechome.nsf/vapubfilesname/F3102CE.pdf/$file/F3102CE.pdf You want page 29 of 30 of this PDF Murata - http://www.murata.com/catalog/c02e11.pdf Page 132 of the catalog, or 134 of the PDF.
Electronics Forum | Wed Nov 29 01:09:17 EST 2006 | Guess
I would suggest checking the feeder, MVF and MSR are both turret type and dont have the capability auto pik adjust in y. Y offset pick up would lead to : 1. Over turn component. 2. Missing component. Turret sequence is pick, recognize an
Electronics Forum | Wed Dec 06 23:12:09 EST 2000 | Brad
Chris, Have you considered Fuji? The robustness of Fuji is proven. I have recently done floor space analysis and cost per placement/sqr foot studies. I have also performed ROI studies on these machines. The new CP7 machine from Fuji outperforms th
Electronics Forum | Tue Dec 22 17:32:17 EST 2020 | atpico
We are looking to buy a 2nd hand Europlacer p-n-p. We would be very grateful to have a real production competent opinion about EP feeders/trolleys Questions: 1. generally how good/bad are older (Gen1, Gen2) Europlacer feeders and trolleys systems
Electronics Forum | Wed May 24 19:20:55 EDT 2000 | Jerry
Are QP242E and MPIII feeders compatible? Or is there a way to make them compatible by modification?
Electronics Forum | Fri May 31 16:26:22 EDT 2002 | Feederman
Steve, you might want to check out the pre-printed and print-on-demand label feeders that are available through Hover-Davis. These types of feeder remove the potential human placement errors which sometimes occur. The feeders are available for most p
Electronics Forum | Wed Dec 30 13:26:55 EST 2020 | atpico
Hello Dave, Thank you. I certainly look on Used Equipment Mart section. The question was if Gen 1 feeders/trolleys worth to invest or better try to buy EP Gen 2 feeders/trolleys even if significantly much expensier/rare on used machines market.
Electronics Forum | Tue Jan 05 07:31:34 EST 2021 | atpico
Great! Thank you! What about Gen1 vs Gen2(NT) EP feeders (not feeder elements)