Electronics Forum | Wed Jan 27 15:23:25 EST 2016 | dyoungquist
You can buy an awful lot of stencils for $200K but where/how are you going to store all of those stencils? There is a certain $$$ value to all the space it will take to store them. I have been told by a Mycronic salesman that they are working on qu
Electronics Forum | Tue Jan 28 10:28:28 EST 2020 | tamasmagyar
Hello there, I am wondering if there is any other way to program Mycronic MY600 jet printer beside I do with Aegis Factory Logix. The issue that I encounter most of times is that the compiler and the software on its own keeps crashing. Other thing
Electronics Forum | Wed Dec 24 12:01:36 EST 2014 | emeto
Hi, I think that the jet printer is going to work for your process - the key with this device is to maintain it really good so you don't get any clogs. These are very fast devices.
Electronics Forum | Fri Feb 05 15:15:01 EST 2016 | jfbrandon
Why don't you look into a BotFactory Squink? It can deposit solder and pick-and-place. It prints conductive ink for the traces too. $3K is probably spot on for your budget. Check out http://www.botfactory.co
Electronics Forum | Tue Jan 07 13:15:07 EST 2020 | pwebb17
Hello all, I am looking to move my prototype line (My600, Iineo II, Heller 9 zone oven) approximately 5 miles within Michigan (Detroit area). I am looking for suggestions for reputable companies. Thanks!
Electronics Forum | Thu Jul 20 13:32:11 EDT 2023 | spoiltforchoice
I doubt either Mycronic or Essemtec, as the only people who do dispense printing, will want to share their research with you. But clearly they will have followed every valid option to determine what is possible. Time & pressure is not used for anythi
Electronics Forum | Tue Dec 30 20:14:30 EST 2014 | jeff701
We've actually bought a second FX-D, which is intended to mainly handle smaller, higher-volume boards. That will still serve to improve throughput. But at the same time, we're also adding another pick'n'place machine which has a rated speed that's 2
Electronics Forum | Fri Jan 09 04:37:13 EST 2015 | jsolloway
Hi Jeff, We have both a MY500 (4 years) and a 600 (8 months) and were the first in the UK to have both. They work well for us, enough so that we no longer use a stencil printer. Like yourselves we are a high mix CEM we make about 500 different part
Electronics Forum | Wed Oct 07 15:46:36 EDT 2020 | tamasmagyar
Hi Hearse, I currently use a MY600, with a AG Ejector which can place dots between 0.33 and 0.52 mm. The differences for a MY600 with placing small dots is down to ejector and paste. To be able to place dots as small as 0.25 mm, you would need an
Electronics Forum | Fri Jan 02 13:24:00 EST 2015 | deanm
I understand the Camalot and Mydata both have a maximum board length of 20". How do you/would you process a board over 20" as mentioned you sometimes have 49" boards? If a screen printer is an option, have you seen the ESE US-LX3 which has a maximum
