Electronics Forum | Sun Jun 08 16:31:02 EDT 2014 | ipdisplays
Prob totally screwed the pooch... Got more than a little frustrated with not being able to get the stupid software to do what I thought it should do, anyway figured maybe the IEC port was the problem - I have a couple of spare cpu cards, so I swapped
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Tue Oct 03 09:13:42 EDT 2000 | jarnopy
Hi This is what i think: 1. Screen printing is fast and dispenser is quite slow 2. Quality is poor on screen printing. Quality is very good on dispenser (dispenser must have screw+pressure function). 3. Screenprinter (automatic) and dispenser (auto
Electronics Forum | Mon Sep 08 11:38:52 EDT 2014 | spoiltforchoice
They key requirement before any fancy tools is careful storage, stock control, labeling and handling. If your parts are incorrect before they even get to production, you're screwed. As gregp suggests, to get consistently correct value and orientation
Electronics Forum | Fri Oct 26 12:29:22 EDT 2018 | davef
I'm not aware of a standard requirement. One screw hole diameter seems to used commonly.
Electronics Forum | Fri Oct 26 13:16:41 EDT 2018 | slthomas
Is there any chance that something like a riv-nut might be used for mounting purposes or is it just a screw hole?
Electronics Forum | Tue Aug 04 14:56:27 EDT 2015 | sarason
Adding to my previous message this could be solved fairly easily for the general case with a jig made from 3.2 - 4mm aluminium aircraft grade plate. you would machine the bottom side edges to give a 1.6 mm thickness, then machine the top side to leav
