Electronics Forum | Tue May 05 13:44:57 EDT 1998 | Mark Mitchell
Mr. Desrochers; Philips EMT Americas offers a three day course entitled, "Introduction to SMT Manufacturing". The course addresses all major factors that influence the automated SMT assembly process. Topics that are discussed in the course are list
Electronics Forum | Mon Oct 31 19:17:47 EDT 2011 | tpappano
One of my CSM84VZs sometimes insists on "error 120, No Point" and also, today when configuring for a new pcb, "error 118, divide by zero". I see nothing in the board data to suggest divide by zero problems. The "no point" error showed up when I add
Electronics Forum | Wed Nov 02 00:48:05 EDT 2011 | tpappano
Thanks for the reply, all the parameters are being entered, but there is something subtle causing the error messages, likely some silly thing I'm overlooking. Hopefully someone is familiar with these error messages, because the manual hasn't been mu
Electronics Forum | Mon Nov 07 20:52:39 EST 2011 | jeffr
Tom, V3.78 is truely a bad version and does not include GLOAD. Files taken from the machine with V3.93 can stumble, but can be read... so I would recommend burning V3.93 EEPROMs. Only do this if both machines have Vision and DC Servo Motors present.
Electronics Forum | Tue Nov 01 09:54:42 EDT 2011 | emeto
Hi , I would think that when you added the new parts, you missed to give them some of the parameterrs and that's why you start to get error messages. Check part parameters(I don't know if you are talking about pick and place machine or some other mac
Electronics Forum | Tue Nov 08 21:56:23 EST 2011 | tpappano
Hi Jeff, both units have DC servos, and both appear to have the same vision system, although #2 has an additional upward-looking camera with a high magnification lens for die mounting. If I could make use of your hex files, that would be great sinc
Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Sun Nov 06 19:20:23 EST 2011 | jeffr
Tom, Does this only happen on one job or all jobs ? If this happens again..you should clear the RAM memory, but changing the 10 year 3v lithium battery on the motherboard should also be considered at the same time. RAM CLEAR PROCEDURE: Power off, rem
Electronics Forum | Mon Nov 07 15:05:16 EST 2011 | tpappano
Hi Jeff, This machine (my unit #2) has a couple programs that execute just fine, but when I added additional mounts to one of them I got the "120"error. When I added another new program, the "118" error showed up, and of course, everything in all t
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s