Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Wed Mar 23 09:32:34 EDT 2016 | dhollland
Can someone explain to me how the scan position of the lead check works and it measured? On our machine the scan position was at .2. I changed this to .1 and could not get a QFP to pass lead check. I then placed it at .25 and haven't had any failur
Electronics Forum | Mon Jul 08 16:03:06 EDT 2019 | slthomas
My recollection is that there is a carrier clip locator that positions (centers) the clip in front of the CTA. Has the adjustment on that been confirmed as well? (Edited because some of it's coming back to me!): I think there is a diamond shaped pin
Electronics Forum | Tue Jan 29 13:06:40 EST 2002 | Sergio Vito - Alan Patrick - Cristiano Dick
Dear sirs, We are experiencing problems with lines of lead formed inside the solder joint. In others words, there is a problem with the formation of the solder joint, after analyses on a microscope we can see the lead grouped in some positions. This
Electronics Forum | Wed Sep 30 20:35:51 EDT 2020 | erici
Hi all, was wondering if you have any ideas on how to correct the problem we are encountering with our S25 machine. The machine is giving an X-axis counting error at gantry 1. I replaced the x-axis linear reader and the linear scale as well, but st
Electronics Forum | Thu Sep 08 13:07:18 EDT 2016 | claudea2
Hello Bob, we changed the nozzle z parameter until we got limit errors and backed up 1 mil. There was a slight reduction in the limit errors on the pickup of the component but it is still a problem. With the mod code we adjust the soft z height to ab
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Mon Apr 08 14:07:25 EDT 2024 | kingkelvin
Hello all - so I got in the calibrate plate for hydra tool offsets - it completed the calibration - I then installed the first row of white tips with the menu - and the machine still does same thing it puts the tips away but makes a hitting type nois
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Thu Oct 06 17:34:07 EDT 2011 | jrsmachine
Hello Tom. Thks for your response. I tryed all your suggestions. No luck. This is how it happened: Several weeks ago I allowed an inexperienced unsupervised operator to work on some program changes. When I checked back afew hours later I noticed
