Electronics Forum | Thu Mar 31 11:13:33 EDT 2022 | jzeivel
I forgot to mention in my original post, I actually replaced the theta belt and cleaned the head. All the tools rotate as they should. When I run the burn-in I get no errors. I can run the "test sub-systems" on the head in the service program and
Electronics Forum | Wed Jan 29 18:41:22 EST 2014 | alphatronique
Hi did you look for mechanical issue like friction somewhere ? when init i use very low force buy much more while running that may explain wly machine work in production fur fail only on init i face that whit flex cable that make just little fr
Electronics Forum | Wed Mar 30 19:37:17 EDT 2022 | jzeivel
I have an MY200DX mycronic pick and place machine. I recently started getting this error "F-MOT-MOVENICE HYDRA Theta2/1295: Encoder Signal is noisy". Has anyone else ever had this error? The machine will still run, but this error will pop up rando
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Thu Jun 08 22:54:57 EDT 2017 | palsrvs
Hoping to get help on our Samsung CP40. We are trying figure out what part to replace for a Z height motor alarm detected Error Code 1523. Originally Head 1 was having this error. Swapped out I/O board and Z-Axis control for head one and same error s
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Tue Jan 24 13:02:55 EST 2023 | elpos
Hello everyone ! I would like to ask for some help regarding the component aligner on the Samsung CP20CV machine (I just bought the machine and I am still learning to use it). I noticed that sometimes when I instruct the Head1 to pick up (any) nozz
Electronics Forum | Fri Apr 12 19:20:25 EDT 2013 | microaide
Some progress, now stuck again. I can now generate a pick and place program for two heads that actually runs the head 1 program when loaded into the central controller of machine #1. But all attempts at getting machine #2 to run the head 2 program ha
Electronics Forum | Fri Jun 09 07:32:13 EDT 2017 | bukas
it sounds to me like a home sensor. try adjusting sensitivity if possible. move head manually to determine position at which home sensor is activated
